Use and Care Guide

Table Of Contents

Use as directed. To ensure proper performance, please be sure to contact us if you have installation or operation questions.

3. Emptying

Procedure

REMOVE SOIL SOLLCTING TRAY

Ensure that the soil collecting tray is empty by pulling it out. If Envirolet®/SG has been use recently,

liquid may be evident. If so, do not empty at this point and, as directed, let the system “sit” to allow

for evaporation.

Soil Collecting Tray Removed from Waterless Self-Contained System

RE-INSERT SOIL COLLECTING TRAY

Push empty Tray back into position so it is ready to collect your compost.

USE RAKE BAR

• Begin emptying compost by agitating the Rake Bar (bottom) on system front.

• This will release the composted soil into the empty tray.

• Check the Tray often to alert you when it is full.

• Depending on volume, you may have to empty the Tray more than once.

Rake Bar Note

The Rake Bar is a series of blade-like cutters with tiny rakes attached. It only pulls “in and out”

approximately 2-3” or 5-8cm.

REMOVE TRAY AND DISPOSE OF COMPOST

Dispose of the emptied compost properly, according to local guidelines. In most cases it can be

disposed of in your flower garden, buried or sprinkled in the forest. In some areas or jurisdictions

you may be required to dispose of compost with your regular trash.

4. Clean Tray & Filters

Emptying is a good time to clean the tray and the 2-Stage Pre-Sediment Filters (standard on

all Envirolet®/SG Non-Electric, 12VDC, Low Water Remote and FlushSmart VF models). These

should be cleaned with a warm soapy water and rinsed prior to putting it back inside your system.

Harsh chemicals are not recommended. Filters cloths are located in your tray (back corners) and

the Filter Tube is located under your tray.

5. Check Gasket &

Before re-attaching the Bottom Panel, inspect your Bottom Panel Rubber Gasket (located on the