Specifications

14
10.1 Once installed the lling and the heating cycles of the Speediboil are
completely automatic.
10.2 To dispense water, place a suitable container under the outlet spout and pull
the tap handle down and towards (or pushed away) the user. The water
dispensed will at all times be boiling or close to boiling point so due caution
must be taken when using the product.
10.3 The tap handle is spring loaded so that when released it will spring back to the
“off” position (no ow).
10.4 The Speediboil is tted with one neon indicator
When the neon is ashing the unit is commissioning (DO NOT draw water off).
When the neon is on and stays as a solid light the unit is ready to be used.
10.5 If the store of hot water is completely withdrawn, the ow rate from the outlet
tap will reduce to the lling rate of the heater (leave for 2 minutes before
drawing any more water off). This slow ow rate allows the incoming water to
be instantly reheated, it does not indicate a fault with the water heater.
10.6 If the Speediboil is not used for a few days the water may become “stale”. In
these instances it is advisable to draw off the contents and discard the water
at least twice to remove the “stale” water. This will ensure that “freshly” boiled
water is used to make your drinks etc.
10.7 Similarly, if left unused it is possible that some scale residue will collect in the
outlet tap. This will cause the outlet water to appear “milky” for a short while.
If this condition occurs it is recommended that the rst few cups are drawn off
and discarded.
10.0 USER INSTRUCTIONS