Instructions / Assembly

3. Unroll the wall in a clockwise direction and fit it into the Base

Rail.

4. Join the two ends of the wall together in the center of the bottom,

metal bracket. If the holes do not align, adjust the gaps of the

Base Rail as needed.

5. Using Bolt (R), Washer (Q) and Nut (P), secure the ends of the

pool wall together.

IMPORTANT: The Bolt (R) must be on the inside of the pool wall.

6. Using the supplied tape (L), tape over the inside bolt heads,

securing the top of the tape to the first bolt as shown.

7. Check the level of the pool to ensure the deviation is not more

than 1" from one side to the other.

WARNING: An uneven pool can collapse.

Preparing The Floor/Base Of The Pool.

IMPORTANT: An even and sufficient base/floor of the pool will

create a cushioned, smooth surface; protecting the liner and

preventing wrinkles from forming in the liner.

RECOMMENDED: The use of a LinerLife ground pad with help to

protect your pool liner. Item numbers for precut pads are GP18R for

an 18' round pool and GP24R for a 24' round pool.

1. Evenly spread the required amount of sand (2" sand base)

throughout the pool area, using a landscaping rake for the initial

spread of sand and then a push broom for fine smoothing.

2. Create a cove along the base/perimeter of the pool wall that is

6" x 6".

OPTIONAL: Tamp the sand using a hand tamper or use a sod

roller to set the sand and smooth out any imperfections.

Installing The Pool Liner And Pool Framing

NOTE: The liner will include instruction inside the box from the

manufacturer. The following steps are general steps of installing the

liner. Please read the instructions in the liner box for complete

information. (Liners not provided with all packages).

IMPORTANT: Do NOT open the liner box with a knife as you may

cut the liner.

IMPORTANT: The outside temperature should be above 70°F

when installing the liner.

NOTE: Using cardboard or other non-sharp material to distribute

the weight of a ladder or while walking on the inside of the pool will

help to reduce disruption of the pool base.

1. Unroll and unfold the liner on the inside of the pool.

2. Pull the seam of the liner (from the wall to the floor) evenly

toward the wall off the pool.

3. Fold the liner over the wall of the pool ensuring that the seam of

the liner falls in the middle of the sand cove as shown.