User Guide

ManualsBrandsSanus Systems ManualsCell PhoneNF213

Assembly Instructions for Natural Furniture, Models: NF203, NF213, NFV49

Thank you for choosing the Natural Furniture line from Sanus Systems. If you have any questions regarding this or any

other Sanus Systems product, please contact us at 800.359.5520 or visit us at www.sanus.com. Our customer service

representatives can assist you quickly with any issues regarding assembly or missing parts. Check carefully to make sure

none of the parts are missing or defective. Never use defective parts. Replacement parts for products purchased from an

authorized dealer will be shipped directly to you. Please call Sanus Systems before returning products to retail stores.

Supplied Parts List: (Threaded fasteners are shown full size)

Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 04.06.06 (100043)

Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com

Steel Cross Tube- B

Qty. 12

Front Frame - A

Qty. 1

Wire Strap - H

Qty. 4

Top Glass Shelf - G

Qty. 1

Glass Shelf - D

Qty. 2

Plastic Wire Cover - F

Qty. 2

Three Hole Plate - C

Qty. 8

Rear Support - E

Qty. 2

Summary of content (4 pages)

PAGE 1
Assembly Instructions for Natural Furniture, Models: NF203, NF213, NFV49 Thank you for choosing the Natural Furniture line from Sanus Systems. If you have any questions regarding this or any other Sanus Systems product, please contact us at 800.359.5520 or visit us at www.sanus.com. Our customer service representatives can assist you quickly with any issues regarding assembly or missing parts. Check carefully to make sure none of the parts are missing or defective. Never use defective parts.
PAGE 2
Allen Bolt - I Qty. 12 Washer - J Qty. 4 Decorative Face Bolt - K Qty. 12 Allen Key - M Qty. 1 Glass Protector - L Qty. 8 Step 1: Attach the Cross Tubes to the Front Frame Position the Front Frame (A) as shown in Diagram 1; then, thread each Decorative Face Bolt (K) through the Front Frame, a Three Hole Plate (C) and into a Steel Cross Tube (B). Repeat this process until all twelve Steel Cross Tubes (B) are fastened to the Front Frame (A) as shown in Diagram 1.
PAGE 3
Step 2: Attach Rear Supports NOTE: The Rear Supports (E) must be positioned with set of three holes closest to the edge toward the top and the horizontal slots facing the Front Frame (A). Thread an Allen Bolt (I) through a Washer (J), the middle hole in a Rear Support (E), the middle hole in a Three Hole Plate (C), and into the middle Steel Cross Tube (B), as shown in Diagram 2.
PAGE 4
Step 4: Add Top Glass Shelf Place four Glass Protectors (L) evenly along the top of the Front Frame (A); then, add two Glass protectors to the top of each Rear Support (E). Place the Top Glass Shelf (G) onto the Glass Protectors as shown in Diagram 4.