TV Mount User's Manual

Step 7: Leveling the Monitor and Adjusting the Tension
CAUTION: Do not remove the Tension Nuts in Diagram 7. Removing Tension Nuts will result in property damage.
Once the television is mounted onto the Wall Plate (A), and the Safety Bolts (N) are tight, it can be adjusted to level. Slightly loosen
the two Allen Bolts on the back of the Arm Assembly (B). Once the Allen Bolts are loosened, the television can be adjusted ±6º until
level. When the television is level retighten the two Allen Bolts. The tilt can be adjusted by setting the tension of the Tension Knobs
and tilting the television. The Tension Nuts labeled in Diagram 7 can be slightly loosened or tightened using the 7/32 Allen Key (K)
and wrench to adjust the tension of the Arm Assembly. If you need to adjust the Tension Nut closest to the TV, you must remove
the Safety Bracket, adjust the tension and re-install the Safety Bracket as shown in Safety Bracket Installation.
Safety Bracket Installation
Diagram 7
Step 6: Hang the assembly onto the Wall Plate
CAUTION: This step may require two people to lift the assembly onto the Wall Plate. Sanus is not responsible for
property damage and/or personal injury.
Orient the Arm Assembly (B) so the arm extends directly away from the television and the Transfer Plate is parallel with the
television. Lift the assembly and hook the Transfer Plate onto the tab on the top of the Wall Plate (A) as shown in Diagram
6a. Horizontally adjust the Transfer Plate side to side on the Wall Plate until it is in the desired location.
CAUTION: make sure the Saftey Bolt (N) is tight. A loose Safety Bolt will result in an unstable installation which
may result in property damage and/or personal injury.
Thread each Safety Bolt (N) into one of the three holes in the bottom of the Transfer Plate and tighten them so that they are
behind the Tab on the bottom of the Wall Plate as shown in Diagram 6b.
Diagram 6a Diagram 6b
Transfer Plate
A
B
N
Tab
Tension
Knob
Tension
Nut
Tension
Nut
Allen
Bolt
Safety
Bracket
B
N
A