SANS SYSTEMS THE ONION OF FORM AND FUNCTION Assembly Instructions for AMPLE@ Flat Panel Wall Mount Thank you for choosing a Bluepoint wall mount, This product is designed to mount flat panel televisions weighing up to 130 1b. to a vertical wall. It allows you to tilt your new television up to 12° without the use of tools. Safety Warning: If you do not understand these directions, or have any doubts about the safety of the installation, please call a qualified contractor or contact Anus at 800.359.
Step 1: Mounting the Wall Plate: Wood Stud, Brick, Solid Concrete, and Concrete Block mounting options are provided. Wood Stud mounting: The Wall Plate (2) must be mounted to two wood studs at feast 127 apart. Use a high quality stud sensor to locate two adjacent studs. It is a good idea to verify where the studs are located with an awl or thin nail shown in Diagram la. Pr-drill a 2.5" deep hole at the desired height in each stud using a 3/16" drill bit.
Step 3: Attaching the Monitor Brackets to a TV with a flat back WARNING: DO NOT LAY THE TELEVISION FACE DOWN ON THE GLASS, lean it up against a wall or other solid surface! Laying the television down on the glass may cause permanent damage. The Monitor Brackets (b,c) should be placed as vertically close to center of the television as possible before installation.
Step 5: Attaching the Monitor Brackets to a television with recessed threaded inserts. WARNING: DO NOT LAY THE TELEVISION FACE DOWN ON THE GLASS, lean it up against a wall or other solid surface! Laying the television down on the glass may cause permanent damage. The Monitor Brackets should be placed as vertically close to center of the television as possible before installation.