EXZES ZZ Radio System Manual

105
TR
EXZES ZZ
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
Telemetry System with Sanwa Synchronized Link Support
Adding Programming Menus to the CUSTOM Menu, Continued:
1) Highlight the Programming Menu you would like to add to the CUSTOM
menu.'C'ENTRYwillbedisplayedintheMessageDisplayWindow.
Removing Programming Menus From the CUSTOM Menu:
1) HighlighttheProgrammingMenuyouwouldliketoremovefromtheCUSTOM
menu. 'C' CANCEL will be displayed in the Message Display Window and a
'C' will be displayed in the Pointer next to the Menu Name, indicating the
ProgrammingMenuispartoftheCUSTOMmenu.
2) Press the SELECT switch in the direction of the arrow (LEFT). A 'C' will be
displayed in the Pointer next to the Menu Name, indicating the Programming
MenuisnowaddedtotheCUSTOMmenuandCANCELwillnowbedisplayed
in the Message Display Window.
2) Press the SELECT switch in the direction of the arrow (RIGHT). The 'C' will be
removed from the Pointer next to the Menu Name, indicating the Programming
MenuhasnowbeenremovedfromtheCUSTOMmenuandENTRYwillbe
displayed in the Message Display Window.
CH-SET MENU
{
CHANNEL SET MENU
}
CUSTOM
TROUBLESHOOTING GUIDE REFERENCE
This troubleshooting guide below and on the next few pages can help you diagnose and solve some of the more common prob-
lems that you may encounter with your EXZES ZZ radio control system. If you cannot solve the problem using this troubleshooting
guide, please contact us directly using the information in the Service and Support section on page 3.
Transmitter does not turn ON
Transmitter will not bind to receiver
Transmitter batteries installed incorrectly
Battery tray not plugged in
Transmitter batteries are dead
Damage caused by using incorrect
charger or reverse polarity
Modulation Type incorrect
Too much time elapsed after pressing
receiver Bind Button
Attempting to Bind incompatible receiver
UsingElectronicSpeedcontrol(ESC)
Receiver batteries are dead
UsingincorrectBindingprocedure
PROBLEM
Reinstall batteries, observing correct polarity
Plug in battery tray
Replace or recharge transmitter batteries
Contact Customer Service
Change Modulation Type to match receiver
Quickly press ENTER key in BIND menu after releasing
receiver Bind Button
UseonlySanwa 2.4GHz FH3, FH4 or FH4T surface
receivers
Disconnect ESC and use dry cell battery for Binding
procedure, then reconnect ESC after Binding
Replace or recharge receiver batteries
Follow Binding procedure carefully
CAUSE SOLUTION
CUSTOM