EXZES ZZ Radio System Manual

12
EXZES ZZ
TR
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
Telemetry System with Sanwa Synchronized Link Support
3) When satisfied with the adjustment, gently tighten the four mounting screws (A) to lock the gimbal in place
The angle of the throttle and steering gimbals can each be adjusted to suit your preference. This allows for the most comfortable
feel during use.
To adjust the gimbal angles, follow the steps below:
1) Usinga2mmhexwrench,loosenthefourmountingscrews(A)aroundtheperimeter
of the gimbal you would like to adjust.
2) After loosening the four mounting screws, carefully twist the gimbal clockwise or
counter-clockwise (B) to suit your preference.
Each gimbal features a Gimbal Angle Adjustment Indicator to aid with alignment.
In the default configuration, the control sticks are adjusted to the lowest position.
When lengthening the control sticks, we strongly suggest that you leave at least four threads inside the top of each control
stick. This will ensure that the control sticks maintain optimum mechanical security. If you thread the control sticks out too
far, the control sticks might come loose during use.
Do not attempt to adjust the gimbal angles beyond the limits indicated by the Gimbal Angle Adjustment Indicators or
damage to the transmitter may result.
The length of the control sticks can be adjusted to best suit the way you hold them. In general, drivers who place their thumbs on
top of the control sticks prefer the control sticks to be shorter, and drivers who grasp the control sticks prefer the control sticks to
be longer. In addition, the angle of the top of the control sticks can be changed to suit your preference. This allows for the most
comfortable feel during use.
To adjust the length of the control sticks and the control stick angles, follow the steps below:
1) Usinga1.5mmhexwrench,loosenthegrubscrew(A)inthetopofthecontrolstick
you would like to adjust.
2) After loosening the grub screw, thread the top of the control stick counter-clockwise
to lengthen the control stick or turn the top of the control stick clockwise to shorten
the clockwise.
3) When satisfied with the adjustment, firmly tighten the grub screw (A) while holding
the top of the control stick in place.
The spring tension of the control sitcks can be adjustetd to suit your preference. Some drivers prefer a firmer feel and some
drivers prefer a softer feel.
In the default configuration, the spring tension is preset to a soft feel.
To adjust the spring tension of the control sticks, follow the steps below:
1) Usinga1.5mmhexwrench,turnthegrubscrew(A)inthegimbalbaseclockwise
to increase the spring tension or turn the grub screw counter-clockwise to lessen
the spring tension.
GIMBAL ANGLE ADJUSTMENT GENERAL
CONTROL STICK LENGTH AND ANGLE ADJUSTMENT
GENERAL
CONTROL STICK SPRING TENSION ADJUSTMENT GENERAL
A
B
A
A
A
A
A