EXZES ZZ Radio System Manual

EXZES ZZ

2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE

Telemetry System with Sanwa Synchronized Link Support

7) Move the Steering Control Stick and Throttle Control Stick to verify that the servos are operating normally, then repeatedly

presstheBACKkeytoreturntotheSTATUSscreen.

Undersomecircumstances,thereceivermaynotoperateafterturningthetransmitterandreceiverON.Ifthisoccurs,

perform the Binding procedure again.

3) ScrollUPorDOWNtohighlighttheBINDmenu,thenpress

the ENTER key to open the BIND menu.

4) While holding down the Bind Button on the receiver, turn the receiver ON. The

Bind LED on the receiver will flash slowly. Release the Bind Button. The Bind

LED will continue to flash slowly.

The Binding function allows you to Bind the transmitter and receiver pair. When new, it is necessary to pair the transmitter and

receiver to prevent interference from transmitters operated by other users. This operation is referred to as 'Binding'. Once the

Binding procedure is complete, the setting is remembered even when the transmitter and receiver are turned OFF, therefore, this

procedure usually only needs to be done once.

The EXZES ZZ features a Safety Link function that is used to program a unique code to each receiver/model pair, preventing

the transmitter from controlling a model that it's not currently programmed for. The Safety Link function is compatible only

with FH4 or FH4T receivers. It's not compatible with FH3 receivers.

Before beginning the Binding procedure, connect the switch harness, servos and the receiver battery to your receiver,

using the diagram in the Receiver Overview Diagram, Connections and Mounting section on page 8. Make sure that both

the transmitter and the receiver are turned OFF.

IMPORTANT: This section details Binding the RX-472 FH4T Super Response SSL receiver with a Safety Link Model number of 1

and with the Channel Response Mode set to SHR mode. If you are Binding an FH3 receiver, or if you prefer to change the Safety

Link Number or the Channel Response Mode, see the BIND Menu section on pages 28 through 30.

5) Scroll DOWN to highlight the BIND [ENTER] option, then press the ENTER key.

The [ENTER] command and LED1 on the transmitter will begin to flash and

the Bind LED on the receiver will flash rapidly, then go out.

6) After the Bind LED on the receiver goes out, press the ENTER key a second time. Both the Bind LED on the receiver and LED1

on transmitter will illuminate solid, indicating that the Binding procedure is complete.

Youmustcompletestep5belowwithin10secondsortheBindLEDwillgoout,indicatingthereceiverhastimedout.If

this occurs, turn the receiver OFF, then repeat step 4.

1) TurnthetransmitterON.TheSTATUSscreenshouldbedisplayed.

2) If BASIC Mode is turned ON (default), press the ENTER key to open the BASIC

menu. If BASIC Mode is turned OFF, press the SELECT switch to highlight the

SYSTEMmenu,thenpresstheENTERkeytoopentheSYSTEMmenu.

Double-check that Modulation is set to FH4T, Telemetry is turned ON, Safety Link is set to 01 and that each channel is set

to SHR. If you want to change any of these settings, see the BIND Menu section on pages 28 through 30.

TRANSMITTER AND RECEIVER BINDING

GENERAL