EXZES ZZ Radio System Manual

42
EXZES ZZ
TR
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
Telemetry System with Sanwa Synchronized Link Support
SYSTEM
VIBRATOR MENU
{
VIBRATION ALERTS AND ALARMS
}
SYSTEM
LCD MENU
{
DISPLAY OPTIONS
}
SYSTEM
The LCD menu allows you to change the contrast of the LCD, the brightness of the LCD Backlight, the Backlight Mode, the
Backlight On-Time and the Backlight Color.
Changing the Contrast, Brightness and Backlight Color settings can make it easier to view the LCD in different lighting conditions
and changing the Backlight Mode and Backlight On-Time affects how the Backlight is turned ON and how long the Backlight
stays ON.
IMPORTANT: Increasing the brightness of the LCD Backlight and/or leaving the LCD Backlight ON at all times will increase
battery consumption. In addition, Decreasing the Contrast value near the lower limit can result in the LCD text becoming
difficult to read. Be careful not to set the Contrast value too low.
Turning Vibration Functions ON and OFF:
1) FromwithintheVIBRATORmenu,scrollUPorDOWNtohighlightthefunction
you would like to change the Vibration value for.
2) PresstheENTERkey,thenscrollUPorDOWNtochoosethedesiredVibration
value, either ON or OFF.
VIBRATOR setting range is OFF or ON. The default setting is OFF.
5) Press the ENTER key, then repeat steps 3 and 4 to change the Vibration value for any other desired functions.
Adjusting the Vibration Level:
1) FromwithintheSYSTEMmenu,scrollUPorDOWNtohighlighttheVIBRATOR
menu.
2) Press the ENTER key to openthe VIBRATORmenu. VIBLEVEL >4 will be
highlighted.
3) PresstheENTERkey,thenscrollUPorDOWNtochoosethedesiredVibration
Level value. Increasing the value will Increase the Vibration Level and
Decreasing the Vibration Level value will Decrease the Vibration Level. This
setting affects all Vibration Functions the same when they're turned ON
VIB LEVEL setting range is 1 to 5. The default setting is 4.
DESCRIPTION
Vibrates When the Transmitter is Turned ON
Vibrates to Indicate the Transmitter Voltage Alert Value is Reached
Vibrates to Indicate the Telemetry Receiver Voltage Alert Alarm Value is Reached
Vibrates to Indicate the Telemetry 1 (Default Temp 1) Alert Alarm Value is Reached
Vibrates to Indicate the Telemetry 2 (Default Temp 2) Alert Alarm Value is Reached
Vibrates to Indicate When the First Interval Timer Starts and Stops
Vibrates to Indicate When the Second Interval Timer Starts and Stops
Vibrates to Indicate When the Lap Timer Pre-Alarm Time is Reached
Vibrates to Indicate When the Lap Timer Goal Time is Reached
Vibrates to Indicate When the Countdown Timer Pre-Alarm is Reached
Vibrates to Indicate When Zero on the Countdown Timer is Reached
VibratestoIndicate1MinuteCountUpTimerAlarmTones
POWER
BATTERY
TLM VOLT
TLM 1
TLM 2
INT1 TIMER
INT2 TIMER
LAP-PRE
LAP GOAL
DOWN-PRE
DOWN-FIN
UP-1MIN
FUNCTION
The table below shows the Vibration Functions that can be turned ON or OFF: