EXZES ZZ Radio System Manual

45
TR
EXZES ZZ
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
Telemetry System with Sanwa Synchronized Link Support
TRIM TYPE MENU
{
SERVO TRIM TYPE
}
SYSTEM
The Trim Type function allows you choose the way servo Trim and servo End Point Adjustments interact with each other. When
you apply Trim to a servo, the Neutral Point of the servo shifts toward the High Side or the Low Side. When you do this, the servo
travels less in one direction and more in the other direction because the servo End Points are stationary. In order to balance the
servotravel,youwouldneedtomanuallyreadjusttheservoEndPoints.UsingtheTrimTypefunctionallowsyoutomaketheservo
End Points shift toward the High Side or the Low Side when you apply Trim. This maintains balanced servo travel without the need
to manually readjust the servo End Points.
The Trim Type function does not effect servo Sub-Trim. It only effects servo Trim that's input using the Trim Switches, Auxiliary
Dial or Auxiliary Lever. Servo Sub-Trim, which is different, always uses Parallel Trim.
Two Trim Types are available:
CENTER - When selected, servo End Points are stationary. In order to balance servo travel, you would need to
manually readjust the servo End Points, if desired.
PARALLEL - When selected, servo End Points shift toward the High Side or the Low Side automatically
when you apply Trim. This maintains balanced servo travel without the need to manually readjust the
servo End Points, however, this could result your model's control linkages binding in one direction or
the other.
Changing the Trim Type:
1) From within the SYSTEMmenu,scrollUPorDOWNtohighlighttheTRIMTYPE
menu.
2) Press theENTERkey to opentheTRIM TYPE menu.ST> CENTwillbe
highlighted.
3) ScrollUPorDOWNtohighlightthedesiredchannelyouwouldliketochange
the Trim Type value for. Choose from either ST (Steering), TH (Throttle),
AUX1(Auxiliary1)orAUX2(Auxiliary2).
4) Press the ENTER key, then scroll UP or DOWN to choose the desired Trim
Type value for that channel.
TRIMTYPEsettingrangeisCENTandPARA.ThedefaultsettingforallchannelsisCENT.
TH TYPE MENU
{
THROTTLE BIAS RATIO
}
SYSTEM
The Throttle Type function allows you to change the ratio between Throttle High Side servo travel and Throttle Brake Side servo
travel. In the default configuration, the Throttle Type is set to F64:B24. This Throttle Type shifts the Throttle Neutral Point toward the
Brake Side, resulting in more servo travel toward the High Side and less servo travel toward the Brake Side.
Some users may prefer the ratio between Throttle High Side servo travel and Throttle Brake Side servo travel to be balanced
(F44:B44) so that servo travel is equal. The F64:B24 Throttle Type is most common for general-use and racing, while the F44:B44
Throttle Type is most common for Rock Crawling.
5) Press the ENTER key, then repeat steps 3 and 4 to change the Trim Type value for any other desired channels.
SYSTEM