EXZES ZZ Radio System Manual

47
TR
EXZES ZZ
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
Telemetry System with Sanwa Synchronized Link Support
CALIBRATION MENU
{
CONTROL CALIBRATION ADJUSTMENT
}
SYSTEM
Calibrating the Steering, Throttle and Auxiliary Lever Controls:
1) From within the SYSTEMmenu,scrollUPorDOWNtohighlighttheCALIBRATION
menu.
2) Press the ENTER key to open the CALIBRATION menu. The ST (Steering)
menu will be highlighted.
Ifyouwanttocalibrateadifferentcontrol,scrollUPorDOWNtohighlight
the control option you would like to calibrate, either TH (Throttle) or
LEVER (Auxiliary Lever).
3) Press the ENTER key to open the ST VR CALIBRATION menu (or the TH VR
CALIBRATION menu or the LEVER VR CALIBRATION menu, depending on
yourselectioninstep2).SETTING>FACTORYwillbehighlighted.
The steps required to calibrate the operation of the Steering Control Stick, Throttle Control Stick and Auxiliary Lever are the
same. The example shown in this section details calibrating the Steering Control Stick.
Two Calibration Options are available:
FACTORY - When selected, control End Points and Neutral positions are set to the original Factory Default Calibration values.
ThisoptionshouldbeusedifthereisaproblemwiththeUserCalibrationvaluesoryouwanttorestoretheFactoryDefault
Calibration values.
USER - When selected, the user manually calibrates the control End Points and Neutral positions. This option should be
used in most all cases as part of a routine maintenance schedule or if you've limited or otherwise adjusted the travel of the
Steering Control Stick.
4) PresstheENTERkey,thenscrollUPorDOWNtohighlightSETTING>USER.
Calibration value information specific to the control you're calibrating will be
displayed. If you're calibrating the Steering Control Stick, NEUT > LEFT and
RIGHT values will be displayed. If you're calibrating the Throttle Control Stick,
NEUT>HIGHandBRAKEvalueswillbedisplayedandifyou'recalibratingthe
AuxiliaryLever,NEUT>HIGHandLOWvalueswillbedisplayed.
IMPORTANT: When completing the steps below, do not complete the steps out of order or the calibration process may not
work correctly.
5) Tocalibrate the control's Neutral Point,scrollDOWNtohighlightNEUT>0.
Depending on the current state of calibration, a value other than 0 may be
displayed.
6) With the Steering Control Stick (or Throttle Control Stick or Auxiliary Lever)
centered,presstheENTERkey.NEUT>0OKwillbedisplayed.
SYSTEM