EXZES ZZ Radio System Manual

49
TR
EXZES ZZ
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
Telemetry System with Sanwa Synchronized Link Support
1) From within the SYSTEM menu, scroll UP or DOWN to highlight the BATT
menu.
2) Pressthe ENTERkey to open the BATTmenu. ALERTVOLT > 6.3Vwill be
highlighted and the current transmitter battery voltage will be displayed.
Changing the Low Voltage Alert Alarm Value:
The Low Voltage Alert alarm will sound to indicate the transmitter battery is getting low and should be recharged. We suggest
stopping use as soon as safely possible and recharging the transmitter battery. The Low Voltage Alert alarm will sound for
approximately 5 seconds each time the transmitter battery voltage decreases by 0.1 volt. To clear this alarm before it turns off
automatically,presstheBACKkeyortheENTERkey.
BATT MENU
{
LOW VOLTAGE ALERT AND LIMIT ALARMS
}
SYSTEM
Changing the Low Voltage Limit Alarm Value:
The Low Voltage Limit alarm will sound to indicate the transmitter battery is dangerously low and should be recharged right
away. The Low Voltage Limit alarm cannot be cancelled. When the Low Voltage Limit alarm sounds, you should stop use as soon
as it's safe, then recharge the transmitter battery.
WARNING: Continuing to use the transmitter after the Low Voltage Limit alarm sounds can result in loss of control of your
model. When the Low Voltage Limit alarm sounds, stop use as soon as it's safe, then recharge the transmitter battery.
WARNING: When using a Lithium battery in your transmitter, NEVER allow the battery to discharge below 3.0V per cell (Li-Fe) or
3.3V per cell (Li-Po), or damage to the battery can occur, which can also result in damage to the transmitter if severe enough.
1) FromwithintheBATTmenu,scrollUPorDOWNtohighlightLIMITVOLT>6.1V.
LIMIT VOLT setting range is 4.0v to 9.0v. The default setting is 6.1V.
2) PresstheENTERkey,thenscrollUPorDOWNtochoosethedesiredLow
Voltage Limit alarm value. We suggest using the value listed in the table on
the previous page that matches the type of transmitter battery you're using.
The Low Voltage Limit alarm voltage value cannot be set higher than
the Low Voltage Alert alarm voltage value.
The Low Voltage Alert alarm voltage value cannot be set lower than
the Low Voltage Limit alarm voltage value.
3) PresstheENTERkey,thenscrollUPorDOWNtochoosethedesiredLowVoltage
Alert alarm voltage value. We suggest using the value listed in the table on the
previous page that matches the type of transmitter battery you're using.
ALERT VOLT setting range is 4.4V to 9.0V. The default setting is 6.3V.
SYSTEM