EXZES ZZ Radio System Manual

52
EXZES ZZ
TR
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
Telemetry System with Sanwa Synchronized Link Support
LOG SETUP MENU
{
TELEMETRY DISPLAY AND RECORDING OPTIONS
}
SYSTEM
MAXSCALEsettingrangeis500to127500RPM,1to999MPHand1to999KM/H.Thedefaultsettingis30000RPM,28MPH
and54KM/H.
TheMaximumScaleMPHandKM/Hsettingrangewillvarybasedonthe10CountDistancevalueprogrammedwhenyou
calibrate the RPM Sensor. For more information, see the Calibrating the RPM Sensor - Changing the 10Count Distance
Value section on pages 52 and 53.
Changing the Maximum Scale Value, Continued:
2) Press the ENTER key, then scroll UP or DOWN to change the Maximum
Scalevalue.ThisvaluedeterminesthemaximumRPM,MPHorKM/Hvalue
thatwillbedisplayedontheTELEMETRYscreenALLandRPMpages.
Calibrating the RPM Sensor - Changing the Ratio Value:
TheRatiovaluecanbechangedifyou'veselectedUNIT>RPM.BychangingtheRatiovalueyouareabletoreadactualmotoror
engine RPM even though the RPM sensor may be mounted to your model's spur gear and not to the motor's pinion gear or the
engine's flywheel.
1) From within the RPM menu and with UNIT > RPM Selected, scroll UP or
DOWNtohighlightRATIO>1.000.
If the RPM sensor is mounted to your engine's flywheel or your motor's pinion gear to read the RPM directly, the Ratio
value should be set to 1.000.
The Ratio value is the gear ratio between the two gears that the RPM sensor is mounted to. For example, if the RPM
sensor is mounted to your spur gear, the Ratio value will be the gear ratio of your spur gear and pinion gear.
RATIO setting range is 1.000 to 64.999. The default setting is 1.000.
3) Press the ENTER key, then scroll DOWN to highlight the second Ratio
value.PresstheENTERkey,thenscrollUPorDOWNtochoosethedesired
second Ratio value. If using the example above, choose 28.
4) If necessary, press the ENTER key, then scroll DOWN to highlight the third
ratiovalue. Press the ENTER key, then scroll UP or DOWN to choose the
desired third Ratio value.
IMPORTANT: To calculate the gear ratio, divide the number of teeth in the spur gear by the number of teeth in the pinion
gear. For example, if your spur gear is 54T and your pinion gear is 14T, the gear ratio is 54 / 14 = 4.18.
2) PresstheENTERkey,thenscrollUPorDOWNtochoosethedesiredfirstRatio
value. If using the example above, choose 4.
Calibrating the RPM Sensor - Changing the 10Count Distance Value:
The10CountDistancevaluecanbechangedifyou'veselectedUNIT>MPHorUNIT>KM/H.Bychangingthe10CountDistance
valueyouareabletocalibratetheRPMsensortoreadyourmodel'sactualspeed,ineitherMPHorKM/H.