EXZES ZZ Radio System Manual

53
TR
EXZES ZZ
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
Telemetry System with Sanwa Synchronized Link Support
LOG SETUP MENU
{
TELEMETRY DISPLAY AND LOGGING OPTIONS
}
SYSTEM
Calibrating the RPM Sensor - Changing the 10Count Distance Value, Continued:
1) With your transmitter and receiver turned ON, and with an Active Telemetry connection, place your model on the ground.
2) Measuringininches(orcentimetersifusingKM/H)fromwhereyousetyourmodelontheground,slowlypushyourmodel
and measure the distance covered to complete 10 full revolutions of the RPM sensor (the Bind LED on your receiver will flash
10 times, indicating 10 full revolutions).
3) FromwithintheRPMmenuandwithUNIT>MPHorUNIT>KM/Hselected,
scrollUPorDOWNtohighlight10COUNTDIST>12.0or10COUNTDIST>30,
dependingontheUNIT>valueselectedpreviously.
4) PresstheENTERkey,thenscrollUPorDOWNtochangethe10CountDistance
value to match the measurement obtained in step 2 above. For example, if
your model traveled 2 feet (55cm) to complete 10 full revolutions, enter 24.0
(forMPH)or61(forKM/H).
10COUNTDISTsettingrangeis0.5to118.0forMPHand1to300forKM/H.
Thedefaultsettingis12.0forMPHand30forKH/H.
IMPORTANT: Changing the 10Count Distance value will change the Maximum Scale value. After calibration, you should
reset the Maximum Scale value back to the value you chose previously.
Battery Low Voltage Telemetry Data Display and Alert Alarm Options
TheVOLTmenuallowsyoutochangethewayreceiverormotorbatteryVoltageinformationisdisplayedontheTELEMETRYscreen
ALL and VOLT pages and when the receiver Low Voltage Alert alarm sounds. For example, the Maximum Voltage value can be
adjustedtocalibratetheVOLTIndicatorontheTELEMETRYscreenALLpage.Inaddition,youcanadjusttheVoltagevaluethat
the receiver Low Voltage Alert alarm will sound at to match the type of receiver or motor battery you're using.
2) PresstheENTERkeytoopentheLOGSETUPmenu,thenscrollUPorDOWN
to highlight the VOLT menu.
Changing the Maximum Voltage Value:
1) From within the SYSTEMmenu,scrollUPorDOWNtohighlighttheLOGSETUP
menu.
3) PresstheENTERkeytoopentheVOLTmenu.MAXVOLT>9.0Vwillbe
highlighted.
SYSTEM