EXZES ZZ Radio System Manual

55
TR
EXZES ZZ
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
Telemetry System with Sanwa Synchronized Link Support
IfusingacustomUnitvalue,refertotheUser'sGuideincludedwithyourTelemetrySensortodeterminewhatvalue
touse.ForinformationaboutNamingaCustomUnitvalue,seetheChangingtheUnitValueNamesectionbelow.
LOG SETUP MENU
{
TELEMETRY DISPLAY AND LOGGING OPTIONS
}
SYSTEM
Changing the Telemetry Name, Continued:
2) PresstheENTERkeytoopentheLOGSETUPmenu,thenscrollUPorDOWN
to highlight either the TLM1 or the TLM2 menu depending on which of the two
Telemetry Ports you want to make changes to. In this example, we've selected
the TLM1 menu.
3) Press the ENTER key to open the TLM1 (or TLM2) menu, then scroll UP or
DOWNtohighlightNAME>[TMP1]orNAME>[TMP2].
4) UsingthesamemethodsthatyouusedtochangetheModelName,change
the Telemetry Name to a name that matches the type of Telemetry Sensor
thatyou'reusing(tomakeiteasilyidentifiableontheTELEMETRYscreen.
For more information, see the Model Name section on pages 23and 24.
Changing the Unit Value:
1) From within the LOG TELEMETRY menu, scroll UP or DOWN to highlight
UNIT>ºF.
2) Press the ENTER key, then scroll UP or DOWN to change the Unit value.
Choose from ºF, ºC (for a Temperature Sensor), or a custom value for another
type of Telemetry Sensor.
UNITsettingrangeisºF,ºCand
[ ]
Custom. The default setting is ºF.
Changing the Unit Name (Custom Unit Value Only):
IfusingacustomUnitvalue,theUnitNamecanbechangedtomatchthetypeofTelemetrySensoryou'reusing.TheUnitName
can consist of up to 2 letters or numbers. RefertotheUser'sGuideincludedwithyourTelemetrySensortodeterminewhatUnit
Name to use.
2) UsingthesamemethodsthatyouusedtochangetheModelName,change
theUnitNametomatchthetypeofTelemetrySensoryou'reusing.Formore
information,seetheModelNamesectiononpages23and24.Youwillnotice
that the MAX, ALERT and MIN values will automatically change to reflect the
newUnitName.
1) After choosing UNIT >
[ ]
in
step 2 above, press the ENTER
key a second time to open
the TELEMETRYUNIT menu.
Changing the Rate and the Offset Values:
The Parameter Data of Telemetry 1 and Telemetry 2 is generated by the Voltage on the receiver Temperature Telemetry Ports
(RX-401 and RX-402 receivers). The Rate and Offset values can be changed to correct the Telemetry Parameter Data to match
the desired Telemetry Display when using a different type of Telemetry Sensor, such as a Fuel Level Sensor, plugged into the
TMP1orTMP2Telemetryports.Formoreinformation,refertotheUser'sGuideincludedwithyourTelemetrySensor.
SYSTEM