EXZES ZZ Radio System Manual

57
TR
EXZES ZZ
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
Telemetry System with Sanwa Synchronized Link Support
Changing the Minimum Value:
TheMinimumvaluedeterminestheMinimumTelemetryParameterDatavaluethatwillbedisplayedontheTELEMETRYscreen
TLM1 or TLM2 page and also calibrates the Low Side of the TLM1orTLM2IndicatorscaleontheTELEMETRYscreenALLpage.
The Minimum value cannot be set Higher than the Alert value or the Maximum value. If necessary, you may need to
Increase these values prior to Increasing the Minimum value.
LOG SETUP MENU
{
TELEMETRY DISPLAY AND LOGGING OPTIONS
}
SYSTEM
1) Fromwithinthe TLM1 or TLM2menu,scrollUP or DOWNtohighlight
MIN>62ºF (orothervaluedependingontheselectedUnitvalue).
2) PresstheENTERkey,thenscrollUPorDOWNtochoosethedesiredMinimum
value.
MINsettingrangeis0.00to158,butwillvarydependingontheselectedUnitvalue.Thedefaultsettingis68.0ºF,32.0ºC
and 20.0
[ ]
Custom.
Changing the Message Name and Message Pop-Up Behavior:
AcustomMessageNamecanbeprogrammedandtheMessagePop-UpbehaviorcanbechangedtocustomizeTelemetry1or
Telemetry 2 Message Alerts. For example, if you're using a Fuel Level Sensor, you can program a Message that says "Low Fuel"
that will pop up on the LCD screen when the Telemetry Alert Alarm value is reached.
1) From within the TLM1 or TLM2
menu, scroll UP or DOWN to
highlightMESSAGE>
[ ]
.
2) Press the ENTER key to open
the TELEMETRYMESSAGE menu.
3) UsingthesamemethodsthatyouusedtochangetheModelName,change
the Message Name as desired. For example, HIGH TEMP or LOWFUEL. For
more information, see the Model Name section on pages 23 and 24.
ThreePop-UpOptions are available:
DEFAULT - When selected, aPop-UpTelemetryAlertthatshowsthecurrentTelemetryParameterDatavaluewillbedisplayed
when the Telemetry Alert value is reached.
MESSAGE - When selected, aPop-UpTelemetryAlertwithyourcustomMessagewillbedisplayedwhentheTelemetryAlert
value is reached.
OFF - When selected, the Telemetry Alert Pop-UpMessagewillbeturnedOFF.
4) FromwithintheTLM1orTLM2menu,scrollUPorDOWNtohighlightPOP-
UP>
DEFAULT
.
5) PresstheENTERkey,thenscrollUPorDOWNtochoosethedesiredTelemetry
AlertPop-Upvalue.
POP-UPsettingrangeisDEFAULT,MESSAGEandOFF.ThedefaultsettingisDEFAULT.
SYSTEM