EXZES ZZ Radio System Manual

59
TR
EXZES ZZ
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
Telemetry System with Sanwa Synchronized Link Support
LOG SETUP MENU
{
DISPLAY ONLY TELEMETRY OPTIONS
}
SYSTEM
Steering and Throttle Output Data Display Adjustments
TheSteeringPointandThrottlePointfunctionsallowyoutocalibratetheTELEMETRYscreenALLpageSteeringandThrottleOut-
put Data Displays, so the Output Data displayed matches your paired transmitter's Steering Control Stick and Throttle Control
Stick movement.
If you don't use the Steering Point and Throttle Point functions to calibrate the Steering and Throttle Output Data Displays,
incorrect Output Data will be displayed. These steps should be performed
after placing the EXZES ZZ in Receiver Mode and Binding it to your other trans-
mitter.
Calibrating the Steering Output Data Display:
1) WiththetransmitterturnedOFF,pressandHOLDtheDISPLAYkeytoturnonly
the Display ON.
2) FromwithintheSYSTEMmenu,scrollUPorDOWNtohighlighttheLOGSETUP
menu.
4) PresstheENTERkey.TheSTPOINTmenuwillbedisplayedandNEUTRAL
POINT>127willbehighlighted.
5) With your other transmitter turned ON and paired with the EXZES ZZ, do the
following:
A) Center the other transmitter's Steering Control Stick, then press the ENTER
key on the EXZES ZZ.
B) Scroll DOWN to highlight LEFT END > 212. Rotate and HOLD the other
transmitter's Steering Control Stick all the way to the LEFT, then press the
ENTER key on the EXZES ZZ.
C)ScrollDOWNtohighlightRIGHTEND>42.RotateandHOLDtheother
transmitter's Steering Control Stick all the way to the RIGHT, then press
the ENTER key on the EXZES ZZ.
The values displayed in the ST POINT fields don't represent actual
Steering Control Stick movement and may vary. Steering Control Stick
movement is displayed as a percentage below the ST POINT fields.
3) PresstheENTERkeytoopentheLOGSETUPmenu,thenscrollUPorDOWN
to highlight the ST POINT menu.
Calibrating the Throttle Output Data Display:
1) WithoutturningthetransmitterON,pressandHOLDtheDISPLAYkeytoturn
only the Display ON.
2) FromwithintheSYSTEMmenu,scrollUPorDOWNtohighlighttheLOGSETUP
menu.
3) PresstheENTERkeytoopentheLOGSETUPmenu,thenscrollUPorDOWN
to highlight the TH POINT menu.
SYSTEM