EXZES ZZ Radio System Manual

65
TR
EXZES ZZ
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
Telemetry System with Sanwa Synchronized Link Support
Beforeproceeding,downloadandsavethelatestFirmwareversiontoaconvenientlocationonyourPC.Updates(when
available) can be downloaded from the EXZES ZZ product page at http://www.sanwa-denshi.com.
Updating the Transmitter Firmware Version:
1) From within the SYSTEMmenu, scroll UPor DOWN to highlight thePC LINK
menu.
2) PresstheENTERkeytoopenthePCLINKmenu,thenscrollUPorDOWNto
highlighttheUPDATEmenu.
WARNING: TheUpdateprocesswilltakeapproximately5to10minutes.MakesurethatbeforestartingtheUpdateprocess
thatthetransmitter'sbatteryvoltageissufficienttocompletetheUpdateprocess.Oncestarted,DONOTSTOPtheUpdate
process and DO NOT unplug the transmitter from your PC!
3) WiththePCLINKManager3softwarerunningandthetransmitterconnected,
presstheSOFTWAREUPDATEbuttononthePCLINKManager3software.
4) Navigate to the folder where you Saved the new Firmware version (.tom file), then select the file and press the Open button. Do
not press the Start button on the PC LINK Manager 3 software yet!
7) PresstheStartbuttononthePCLINKManager3softwareandallowtheUpdateprocesstocomplete.Oncecompleted,The
Operation Was Completed will be displayed on your PC and the transmitter will Reset. Turn the transmitter OFF, unplug the
USBcablefromthetransmitter,thenturnthetransmitterbackONtofinalizetheUpdateprocess.
8) YoucanviewthattheFirmwareupdatewassuccessfulbycheckingthenewFirmwareversionintheINFORMATIONmenu.
5) PresstheENTERkey.PCTRANSMITUPDATEOK?NO/YESwillbedisplayed.
6) ScrollUPorDOWNtohighlightYES,thenpresstheENTERkey.PCSTARTwill
be displayed.
Ifyouwanttogobackorifyoudon'twanttoUpdatetheFirmwareversion
foranyreason,chooseNOorpresstheBACKkey.
PC LINK
{
SAVE TRANSMITTER DATA AND UPDATE FIRMWARE
}
SYSTEM
INFORMATION MENU
{
FIRMWARE VERSION, BOOT SCREEN, AND BASIC MODE
}
SYSTEM
The INFORMATION menu allows you to view the transmitter's current Firmware version, in addition to the transmitter's cumulative
On-Time in Hours and Minutes, and allows you to change the BOOT menu behavior, turn BASIC Mode ON and OFF and change
the direction the Push-Button Scroll Wheel moves the Cursor.
Resetting the On-Time:
CumulativeOn-TimewillaccruewhetherthetransmitteristurnedONorifonlytheDisplayisturnedONusingtheDISPLAYkey.
If Reset to 00:00 after changing or recharging the transmitter batteries, it can be used to determine battery discharge time. The
On-Time is displayed in Hours : Minutes.
1) From withintheSYSTEMmenu,scrollUPorDOWNtohighlighttheINFORMATION
menu.
SYSTEM