EXZES ZZ Radio System Manual

69
TR
EXZES ZZ
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
Telemetry System with Sanwa Synchronized Link Support
Changing the Servo Sub-Trim Values, Continued:
2) FromwithintheSETUPmenu,scrollUPorDOWNtohighlighttheSUBTRIM
menu.
3) PresstheENTERkeytoopentheSUBTRIMmenu.Thecursorwilldefaultto
ST>0.
4) ScrollUPorDOWNtohighlightthedesiredSub-Trimvalueyouwouldliketo
change.
5) PresstheENTERkey,thenscrollUPorDOWNtoIncreaseorDecreasethe
Sub-Trim value only enough to center the servo horn.
6) Press the ENTER key, then repeat steps 4 and 5 to change any other desired
Sub-Trim values.
STsettingrangeisR150toL150,THsettingrangeisH150toB150,AUX1settingrangeisH150toL150andAUX2setting
range is H150 to L150. The default setting for all channels is 0.
IMPORTANT: Changing the Sub-Trim values will alter the servo's End Points. After changing the Sub-Trim values, use the
End Point Adjustment function to Reset the servo End Point Adjustment Percentage Values. For more information, see the
EPA Menu section on pages 66 and 67.
SUB TRIM MENU
{
SERVO CENTERING
}
SETUP
REV MENU
{
SERVO REVERSING
}
SETUP
The Servo Reversing function allows you to electronically switch the direction of servo travel. For example, if you rotate the Steering
Control Stick to the Right, and the Steering servo moves to the Left, you can use the Servo Reversing function to make the Steering
servo move to the Left. The Servo Reversing function is available for all four channels.
When you change the direction of servo travel, the servo horn may no longer be centered. If this occurs, use the Servo
Sub-Trim function to center the servo horn. For more information, see the
Changing the Servo Sub-Trim Values section on pages 68 and 69.
Changing the Servo Reversing Values:
1) FromwithintheSETUPmenu,scrollUPorDOWNtohighlighttheREVmenu.
2) PresstheENTERkeytoopentheREVmenu.ThecursorwilldefaulttoST>NOR.
SETUP