EXZES ZZ Radio System Manual

72
EXZES ZZ
TR
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
Telemetry System with Sanwa Synchronized Link Support
1) FromwithintheSETUPmenu,scrollUPorDOWNtohighlighttheMOAMIX
menu. In the example shown in this section, we've selected Car Type X in the
CARTYPEmenu.
2) Press the ENTER key to open the MOA MIX menu. 100 [FRONT] : 100 [REAR]
will be highlighted.
3) PresstheENTERkey,thenscrollUPorDOWNtochangethePowerDistribution
between the Front and Rear motors. Reducing the [REAR] value will reduce
the available power to the Rear motor (Dig) and reducing the [FRONT] value
will reduce the power to the Front motor (Burn).
UsetheServoMonitoratthebottomoftheMOAMIXINGscreentoview
Throttle channel output.
Choosing the Motor on Axle Power Distribution Values:
YouareabletoprogramDigandBurnfunctionsbychangingthePowerDistributionbetweenthetwomotors.WhenbothFront
and Rear values are balanced, Dig and Burn functions are Inhibited.
Controlling the Motor on Axle Mixing Function:
1) In order to control the Motor on Axle function, the MOA MIX function must be Assigned to either one of the five Trim Switches,
the Auxiliary Dial or the Auxiliary Lever. For more information, see the ASSIGN Menu section on pages 31 through 40.
2) UsetheTrimSwitch,AuxiliaryDialorAuxiliaryLevertoadjustthePowerDistributionvaluestoachievethedesiredresults-either
OFF, Dig or Burn, as described above. A pop-up window will display the current Power Distribution values.
PRO TIP: In the default configuration, switching between OFF, Dig and Burn will happen gradually as you move the Trim
Switch or Auxiliary Dial. This allows you to vary the Power Distribution between the Front and Rear motors. If you prefer to
switch between OFF, Dig and Burn as if they were Assigned to an ON/OFF switch, change the Trim Switch or Auxiliary Dial
Step value to 100. For more information, see the ASSIGN Menu section on pages 31 through 40.
Alternately, switching between OFF, Dig and Burn can be controlled using the Auxiliary Lever. This allows you to quickly
switch between OFF, Dig and Burn and still have the ability to variably change the Power Distribution between the Front
andRearmotors.Tosetthisup,AssignMOAMIXtotheAuxiliaryLever,thenchangetheTWEAK(H)valueto+100andthe
TWEAK(L)valueto-100.Formoreinformation,seetheASSIGNMenusectiononpages31through40.
REAR Throttle (BURN) - When set to 0:100, power will only be distributed
to the Rear motor. Power can be distributed proportionally between the
Front and Rear motors from 0:100 to 99:100
FRONT Throttle (DIG) - When set to 100:0, power will only be distributed
to the Front motor. Power can be distributed proportionally between the
Front and Rear motors from 100:0 to 100:99.
OFF (Balanced) - When set to 100:100 or other balanced value, power
will be evenly distributed between the Front and Rear motors.
The following Motor on Axle Mixing options can be programmed by changing the Power Distribution values:
MOA MIX MENU
{
MOTOR ON AXLE MIXING
}
SETUP