EXZES ZZ Radio System Manual

80
EXZES ZZ
TR
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
Telemetry System with Sanwa Synchronized Link Support
DOWN MENU
{
COUNTDOWN TIMER
}
SETUP
Setting the Finish Time, Continued:
2) PresstheENTERkeytoopentheDOWNmenu.FINTIME>60'willbehighlighted.
3) ScrollUPorDOWNtohighlightthedesiredFinishTimevalueyouwouldlike
to change, either 00' (Minutes) , 00" (Seconds) or 00 (1/100th Seconds).
4) PresstheENTERkey,thenscrollUPorDOWNtochoosethedesiredFinish
Time value.
FIN TIME setting range is 00:00:00 to 99:59:90. The default setting is 60:00:00.
5) Press the ENTER key again, then repeat steps 3 and 4 to change any other desired Finish Time values.
Choosing the Optional Throttle Control Stick Start:
The Throttle Control Stick can be used to Start the Countdown Timer after the Countdown Timer as been placed in Standby by
pressing the Push-Button Switch it's Assigned to. This is much more convenient and accurate than pressing the Push-Button
Switch again to Start the Countdown Timer when you're trying to start your race.
1) From within the DOWN menu, scroll UP or DOWN to highlight START
TRIGGER>OFF.
2) Pressthe ENTERkey, then scroll UP or DOWN tochoose the desired Start
Trigger value, either ON or OFF.
START TRIGGER setting range is OFF and ON. The default setting is OFF.
Starting the Countdown Timer:
To control the Countdown Timer, it must first be Assigned to a Push-Button Switch. If desired, the Countdown Timer can be
Started and Stopped by Assigning it to its own Push-Button Switch, or it can be Started and Stopped along with the Lap Timer by
Assigning it to the same Push-Button Switch as the Lap Timer. Regardless of what you decide, follow the step below to control the
Countdown Timer.
1) Press and HOLD the Push-Button Switch you've Assigned the Countdown Timer to for 3 seconds. An audible Double-Tone
will sound and DOWN
[
STANDBY
]
will be displayed momentarily in a pop-up window, indicating the Countdown Timer is in
Standby. To Start the Countdown Timer, press the Push-Button Switch a second time or pull the Throttle Control Stick if you've
Enabled the Start Trigger function. An audible Double-Tone will sound and the Countdown Timer will start counting Down. An
audible tone will sound in 1 second intervals 5 seconds before the Countdown Timer reaches zero. When zero is reached, a
longaudibletonewillsoundandtheCountdownTimerwillbegincountingUp.
If the Countdown Timer is Assigned to the same Push-Button Switch as the Lap Timer and the Lap Timer is Assigned to
Switch Function 1, LAP will flash and Lap Time information will be displayed in a pop-up window, but the Countdown
Timer will still run in the background.
If you program the Lap Counter to Start when you pull the Throttle Control Stick, the Countdown Timer will not Start un-
less you also program it to Start when you pull the Throttle Control Stick, and vice-versa. For the Throttle Control Stick to
Start both Timers, both the Lap Timer and the Countdown Timer Start Trigger function must be programmed to ON.
Stopping the Countdown Timer:
1) To stop the Countdown Timer, press and HOLD the Push-Button Switch you've Assigned it to for 3 seconds. An audible
Double-Tone will sound indicating the Countdown Timer is stopped. Press and HOLD the Push-Button Switch again for 3
seconds to reset the Countdown Timer to the programmed Finish Time and place it in Standby again.