EXZES ZZ Radio System Manual

84
EXZES ZZ
TR
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
Telemetry System with Sanwa Synchronized Link Support
TRIM MENU
{
SERVO TRIM
}
RACING
The EXZES ZZ features Digital Trim Memory. Any amount of Trim that you set during use using the Trim Switches or through
the TRIM menu is automatically stored in memory for that specific channel and for that specific model. The Trim values for each
model will automatically be loaded when the transmitter is turned ON.
Each time you move a Trim Switch a short audible Tone is heard. When the Trim value reaches 0 (Centered), a longer audible
Tone sounds. This indicates to you that the Trim is centered without the need to look at the transmitter.
In the default configuration, Trim Switch Trm1 and Trm2 move the Steering and Throttle/Brake Trim in 5% increments. If
you want to Increase or Decrease the Trim Resolution, see the Changing the Trim Switch Step Value section on page 34.
In the default configuration, Trim Switch Trm1 controls Steering Trim and
Trim Switch Trm2 controls Throttle/Brake Trim. Auxiliary channel Trim can be
changed while you're driving by Assigning the Trim function to another Trim
Switch or the Auxiliary Dial. For more information, see the ASSIGN Menu
section on pages 31 through 40.
The current Trim positions for all
four channels is shown on the Trim
DisplaysontheSTATUSscreen.
PRO TIP: The Trim function features two different Trim Type options that you can choose from. Choose from either Center Trim
orParallelTrim.Formoreinformation,seetheTRIMTYPEMenusectiononpage45.
Changing the Trim Values:
1) From within the RACING menu, scroll UP or DOWN to highlight the TRIM
menu.
2) PresstheENTERkeytoopentheTRIMmenu.ST>0willbehighlighted.
3) Scroll UP or DOWN to highlight the desired Trim value you would like to
change.PresstheENTERkey,thenscrollUPorDOWNtoIncreaseorDecrease
the Trim value in the desired direction.
4) Press the ENTER key, then repeat step 3 to change any other desired Trim values.
TRIM setting range is 0 to 100 in each direction. The default setting for all channels is 0.
Before changing the Trim values, first verify that all Trim values are set to 0, then adjust the servo Sub-Trim values to center
theservohornsperfectly.Formoreinformation,seetheSUBTRIMMenusectiononpages68and69.
CURVE MENU
{
EXPONENTIAL, ADJUSTABLE RATE CONTROL AND CURVE
}
RACING
TheCURVEmenuallowsyouchoosewhatmethodyouwouldliketousetovarytheamountofservotravelinrelationtothe
amount of control movement. Choose from Exponential, Adjustable Rate Control (ARC) and Point Curve functions. Each of
these three functions offers something different, and which function you choose to use for each channel will be determined by
many factors, including your Car Type, track conditions, driving style and more.
EXPO - Vary the amount of servo travel in relation to the amount of control movement with a fixed Neutral Point.
ARC - Vary the amount of servo travel in relation to the amount of control movement with an adjustable Neutral Point.
POINT - Vary the amount of servo travel in relation to the amount of control movement with nine adjustable Points.
Curve functions can be programmed for each of the four channels. Programming options will differ within each function
depending on the specific channel you're programming. For example, if your Car Type features Front and Rear Steering
and Front and Rear Motors (such as Car Type X), only ST and TH channel options will be programmable, however, both Front
and Rear channels will be programmed with the same Programming Values.