EXZES ZZ Radio System Manual

87
TR
EXZES ZZ
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
Telemetry System with Sanwa Synchronized Link Support
Changing the Rate Percentage Value:
The Rate percentage value determines the amount and type of ARC, either Quick, Mild or Linear (see diagram on the previous
page). When a Positive or Negative ARC percentage value is programmed, a Linear Curve will be created from the Neutral Point.
CURVE MENU
{
EXPONENTIAL, ADJUSTABLE RATE CONTROL AND CURVE
}
RACING
Choosing the Channel and the Curve Type, Continued:
2) Press the ENTER key toopentheCURVEmenu.The<ST>channelwillbeselected.
3) Press the SELECT switch RIGHT or LEFT to choose the desired channel you would like to program ARC for.
Changing the Point Value:
The Point value determines the Neutral Point where the Rate percentage value begins. For example, you may not want the Neutral
PointtobecenteredbetweentheHighandLowEndPoints.YoumightwanttheNeutralPointshiftedtotheRightortotheLeft.
1) FromwithintheCURVEmenu,scrollUPorDOWNtohighlightPOINT>44.
2) PresstheENTERkey,thenscrollUPorDOWNtoIncreaseorDecreasethe
Point value. Increasing the Point value will shift the Neutral Point to one side
of center and Decreasing the Point value will shift the Neutral Point to the
opposite side of center.
POINT setting range is 5 to 95. The default setting is 50 (Centered).
YouareabletoadjustthePointvalueandtheRatepercentagevaluefor
the Throttle High Side and the Throttle Brake Side separately. In addition,
you can even program ARC for one Side and Exponential or Point Curve for
the other Side.
1) FromwithintheCURVEmenu,scrollUPorDOWNtohighlightRATE>0%.
2) PresstheENTERkey,thenscrollUPorDOWNtoIncreaseorDecreasethe
Ratepercentagevalue.UsingaNegativeRatepercentagevaluewillSoften
the control feel around the Neutral Point and using a Positive Rate percentage
value will Heighten the control feel around the Neutral Point.
RATE setting range is -100% (Mild) to 100% (Quick). The default setting is 0% (Linear).
Point Curve Programming
The Point Curve function allows you to vary the amount of servo travel in relation to the movement of the Steering Control Stick
and Throttle Control Stick (or in some cases, the Auxiliary Dial and/or the Auxiliary Lever) at different Points along the entire
range of control travel to change the way those functions react to control movement. Nine programmable Points allow you to
create your own custom Point Curve to suit any situation.
The Point Curve function works like the Exponential and ARC functions, except that the Point Curve function allows you to
program up to 9 different Points along the entire range of control travel to suit whatever setup or situation is required. For example,
you can customize the Point Curve to include Mild or Quick Points along the same Curve, or you can create a smooth Point Curve
or a more Linear Point Curve.
4) FromwithintheCURVEmenu,scrollUPorDOWNtohighlighttheTYPE>value.
5) PresstheENTERkeyandscrollUPorDOWNtochooseTYPE>ARC.
RACING