EXZES ZZ Radio System Manual

92
EXZES ZZ
TR
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
Telemetry System with Sanwa Synchronized Link Support
ALB MENU
{
ANTI-LOCK BRAKING
}
RACING
Changing the Lag Value:
The Lag value determines the amount of Delay before the Anti-Lock Braking function Activates after reaching the Point setting.
LAG setting range is 0.00s to 1.00s. The default setting is 0.00s.
1) FromwithintheALBmenu,scrollUPorDOWNtohighlightLAG>0.00s.
2) PresstheENTERkey,thenscrollUPorDOWNtochoosethedesiredLagvalue
in Seconds. Increasing the Lag value increases the Delay time to Activate the
Anti-Lock Braking function after reaching the Point setting and Decreasing the
Lag value decreases the Delay time to Activate the Anti-Lock Braking function
after reaching the Point setting.
OFFSET MENU
{
THROTTLE OFFSET
}
RACING
The Throttle Offset function allows you to shift the Neutral Point of the Throttle servo to a fixed position, either toward the High
Side or the Brake Side, while still allowing you full control of the Throttle. For example, if you're driving a glow- or gas-powered
model, you can use the Throttle Offset function to raise the engine idle for starting or you can program the Throttle Offset function
to Increase the engine to a steady idle while you're refueling during a race. If your model features a separate Brake servo, a Brake
Lock function is featured that can be programmed to apply Brake while the Throttle is increased to keep your model from moving.
The Throttle Offset function shifts the Neutral Point of the Throttle servo without affecting the High Side or Brake Side End
Points. This allows you to have full control over the Throttle even when the Throttle Offset function is turned ON.
Changing the Position Percentage Value:
1) From within theRACINGmenu,scrollUPorDOWNtohighlighttheOFFSET
menu.
2) Press the ENTERkey to openthe OFFSET menu.OFFSET > OFF will be
highlighted.
3) ScrollUPorDOWNtohighlightPOSITION>0%.
4) Pressthe ENTER key,then scrollUP or DOWNto choose thedesired High
Side (H) or Brake Side (B) Position percentage value. The Position percentage
value determines the position the Throttle servo Neutral Point will shift to
when the Throttle Offset function is turned ON.
Turning the Throttle Offset Function ON and OFF:
1) FromwithintheOFFSETmenu,scrollUPorDOWNtohighlightOFFSET>OFF.
2) PresstheENTERkey,thenscrollUPorDOWNtochoosethedesiredOffset
value, either ON or OFF.
OFFSET setting range is ON and OFF. The default setting is OFF.
Remember, the Throttle Offset function can be turned ON and OFF using Push-Button Switch Sw1 without needing to
access the OFFSET menu to turn it ON and OFF.
POSITION setting range is H100% to B100%. The default setting is 0%.
Throttle Offset Programming Values can be changed while you're driving by Assigning these functions to a Trim Switch, the
Auxiliary Dial or the Auxiliary Lever. For more information, see the ASSIGN
Menu section on pages 31 through 40.
In the default configuration, Push-Button Switch Sw1 turns the Throttle
Offset function ON and OFF. When the Throttle Offset function is turned ON,
[
OFFST
]
ON will be momentarily displayed in a pop-up window, LED1 will
flash and an Audible Alarm will sound until the Throttle Offset function is
turned OFF.