EXZES ZZ Radio System Manual

97
TR
EXZES ZZ
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
Telemetry System with Sanwa Synchronized Link Support
C-MIX1 AND C-MIX2 MENU
{
COMPENSATION MIXING 1 AND COMPENSATION MIXING 2
}
RACING
Changing the Master Channel, Continued:
2) PresstheENTERkeytoopentheC-MIX1menu.MASTER>STwillbehighlighted.
3) PresstheENTERkey,thenscrollUPorDOWNtochoosethedesiredMaster
channel.
Changing the Slave Channel:
1) FromwithintheC-MIX1menu,scrollUPorDOWNtohighlightSLAVE>TH.
2) PresstheENTERkey,thenscrollUPorDOWNtochoosethedesiredSlave
channel.
Channels denoted with a Pound (#) sign cannot be chosen as Slave
channels.
When the Master and Slave are set to the same channel, Mixing takes place within the channel itself. This causes servo
travel to Increase for Positive Rate percentage values and servo travel to Decrease for Negative Rate percentage values.
Changing the Rate 1 and Rate 2 Percentage Values:
TheRatepercentagevaluesdeterminetheamountanddirectionofSlavechannelservotravel.UseaPositiveorNegative
percentage value to change the amount and direction of travel. The Right side of the graph indicates Rate 1 percentage values
and the Left side of the graph indicates Rate 2 percentage values.
1) From within the C-MIX1 menu, scroll UP or DOWN to highlight either
RATE1>0%orRATE2>0%.
2) PresstheENTERkey,thenscrollUPorDOWNtochoosethedesiredRate1
or Rate 2 percentage value.
RATE1 and RATE2 setting range is -150% to 150% . The default setting for
both Rate percentage values is 0%.
WARNING: The Rate percentage values can be set Higher than your Slave channel servo End Points (up to 144% in either
direction). To avoid damage to your model, we don't suggest programming Rate percentage values that exceed your Slave
channel servo End Points.
Adjust the Offset value to move the vertical axis and erase the Trim Deviation from the Master Travel Indicator. If there is
no Trim Deviation displayed, you can simply position the starting point of your Mix by choosing the desired Offset value.
Changing the Channel Offset Value:
The Offset function allows you to shift the Neutral Point of the Slave channel servo
to compensate for any Master channel servo Trim or to change the actual starting
point of your Mix.
1) With the Master channel control centered, check the Master Travel Indicator
at the bottom of the graph to see if any Master channel Trim is displayed (see
arrow at right).
2) FromwithintheC-MIX1menu,scrollUPorDOWNtohighlightOFFSET>0.
3) PresstheENTER key, thenscroll UP orDOWNto choose thedesired Slave
channel Offset value. Increase or Decrease the Offset value to move the vertical
axis in the desired direction, adjusting the Slave channel servo Neutral Point.
OFFSET setting range is -150 to 150 . The default setting is 0.
RACING