Manualshelf

User's Manual

ManualsBrandsSanwa Electronic Instrument ManualsElectronicsDigital High Response Telemetry System
12345678910
54
90478 2.4GHZ FH4T RADIO SYSTEM USER'S GUIDE
TR
TR
TR
The Key Assignments function allows you to assign the ON/OFF control of various functions to Push-Button Switches Sw1 and
Sw2. This allows you to use the Push-Button Switches to turn functions OFF and ON during use. One function can be assigned
to each Push-Button switch, although both Push-Button Switches can be OFF or ON at the same time. In addition, the ON/OFF
behavior of some Push-Button Switch Key functions can be changed.
When you program a function, that function is ON (Active) by default, unless the function's default ON/OFF value is OFF
as noted in the table below. To toggle the function OFF and ON it must be assigned to a Push-Button Switch.
This table shows the different functions that can be programmed to the two Push-Button Switches:
Changing the Push-Button Switch Function:
1) From within the SYSTEM menu, scroll UP or DOWN to highlight the KEY ASSIGN menu.
03.KEY ASSIGN
(
KEY ASSIGNMENTS
)
SYSTEM
SWITCH
(
Push-Button Switch Key Assignments
)
Inhibited
Dual Rate-Steering
Dual Rate-Throttle
Dual Rate-Brake
Curve-Steering
Curve-Steering
Servo Speed-Steering
Servo Speed-Throttle
Anti-Lock Braking
Throttle Offset
Auxiliary 1 Channel 3
Auxiliary 2 Channel 4
Auxiliary 1 CODE1
Auxiliary 1 CODE2
Auxiliary 1 CODE3
Auxiliary 1 CODE4
Auxiliary 1 CODE5
Auxiliary 2 CODE1
Auxiliary 2 CODE2
Auxiliary 2 CODE3
Auxiliary 2 CODE4
Auxiliary 2 CODE5
Timers
Telemetry Clear
Telemetry Logger
Sw2
Sw1
------
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
OFF
OFF
OFF
OFF
D/R-ST
D/R-TH
D/R-BR
CUR-ST
CUR-TH
SPD-ST
SPD-TH
ALB
OFFSET
AUX1
AUX2
A1CODE1
A1CODE2
A1CODE3
A1CODE4
A1CODE5
A2CODE1
A2CODE2
A2CODE3
A2CODE4
A2CODE5
TIMER
TE-CLR
LOGGER
------
Toggle
Toggle
Toggle
Toggle
Toggle
Toggle
Toggle
Toggle
Toggle
Toggle
Toggle
Toggle
Toggle
Toggle
Toggle
Toggle
Toggle
Toggle
Toggle
Toggle
Toggle
------
------
------
MENU FUNCTION DEFAULT SWITCH
DEFAULT MODE DEFAULT ON/OFF
2) Press the ENTER key to open the KEY ASSIGN menu. SWITCH will be highlighted.
3) Press the ENTER key. The SWITCH menu will be displayed and SW1:LOGGER will be
highlighted.
MT-4S User's Guide.indd 54 2015/10/27 14:39:10