User's Manual
Page 4
DRIVING POSITION ADJUSTMENTS
STEERING WHEEL TENSION
Every effort has been made to provide optimum transmitter weight and balance on your M11X FHSS 2.4GHz radio control
system. The wheel and trigger are placed on the same axis, permitting you to focus on steering and throttle control. The driving
SRVLWLRQDQGVWHHULQJWKURWWOHWHQVLRQDUHDGMXVWDEOHWRPD[LPL]HGULYLQJSUHFLVLRQ
The steering wheel spring tension can be adjusted using a
PPKH[ZUHQFKDVVKRZQDWULJKW7RLQFUHDVHVWHHULQJ
ZKHHOVSULQJWHQVLRQWLJKWHQWKHKH[VFUHZWXUQFORFNZLVH
To decrease steering wheel spring tension loosen the hex
VFUHZWXUQFRXQWHUFORFNZLVH
DRIVING POSITION
The driving position height can be adjusted to change the
balance (feel) of the transmitter in your hand.
THROTTLE TRIGGER TENSION
The throttle trigger spring tension can be adjusted to suit
your taste.
The spring tension is factory set at the lowest (softest)
position.
5HPRYHWKH0VRFNHWKHDGFDSVFUHZVRQHDFKVLGH
of the transmitter using a 3mm hex wrench.
'HWDFK WKH JULS GRZQZDUG IURP WKH XSSHU WUDQVPLWWHU
unit. Be careful to avoid damaging the lead wires that
are connected on both units.
3) There are four phillips head screws holding each side
RIWKHJULSEUDFNHW5HPRYHWKHVFUHZVDQGUHVHWWKH
EUDFNHWVFUHZKROH DWWKHORZHU VFUHZ KROH7KLVVHWV
WKHEUDFNHWWRWKHKLJKHUKHLJKWSRVLWLRQ
4) After resetting the driving position, retighten the grip
EUDFNHW VFUHZV WKHQ DOLJQ WKH XSSHU WUDQVPLWWHU XQLW
DQGUHLQVWDOOLWXVLQJWKHWZR0VRFNHWKHDGFDSVFUHZV
7KHWUDQVPLWWHUVKLSVZLWKWKHJULSEUDFNHWLQWKHORZHU
height position.
5HPRYHWKH0VRFNHWKHDGFDSVFUHZVRQHDFKVLGH
of the transmitter using a 3mm hex wrench.
'HWDFK WKH JULS GRZQZDUG IURP WKH XSSHU WUDQVPLWWHU
unit. Be careful to avoid damaging the lead wires that
are connected on both units.
$GMXVW WKH WKURWWOH WULJJHU VSULQJ WHQVLRQ XVLQJ D
mm hex wrench as shown at right. To increase throttle
trigger spring tension tighten the hex screw (turn
FORFNZLVH7RGHFUHDVHWKURWWOHWULJJHU VSULQJWHQVLRQ
ORRVHQWKHKH[VFUHZWXUQFRXQWHUFORFNZLVH
4) After resetting the throttle trigger spring tension, align
the upper transmitter unit and reinstall it using the two
0VRFNHWKHDGFDSVFUHZV
The spring tension is factory set at the lowest (softest)
position.