User's Manual

15
M12S 2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
TR
4) Being careful not to pinch any connectors or wires, align and secure the offset
plate to the transmitter using one M3 x 14mm socket-cap screw (B) and
two M3 x 8mm philips head screws (C).
5) Align and secure the angle plate to the offset plate, using the three
M3 x 8mm philips head screws (D) included.
6) Being careful not to pinch any connectors or wires, align
and secure the Trim Switch assembly to the offset
plate using the three larger philips head screws
(E) you removed previously.
7) Reinstall the Steering Wheel. Installation is the
reverse of removal.
Two optional Steering Wheel angle plates (one Right and one Left) are included that angles the position of the Steering Wheel
and Trim Switch assembly. Some users may find that angling the Steering Wheel to the Right or Left may be more comfortable
during use.
A
A
A
To install the Right or Left Steering Wheel angle plate, follow the steps below:
1) Use a 7mm nut driver to remove the Steering Wheel retaining nut, then pull the
Steering Wheel straight off and set is aside.
2) Using a philips head screwdriver, remove the three larger philips head screws (A),
then carefully pull the Trim Switch assembly off the transmitter and very carefully
unplug the two connectors.
C
3) Choose which angle plate you want to install, then align
and secure the angle plate to the transmitter, using the
three M3 x 8mm philips head screws (B) included. There
are small notches in both the Trim Switch assembly and
the angle plate that line up with corresponding small tabs
in the angle plate and the transmitter to ensure both the
Trim Switch assembly and the angle plate are installed in
the correct orientation.
4) Very carefully plug the connectors from the Trim Switch
assembly into the matching connectors in the transmitter.
5) Being careful not to pinch any connectors or wires, align
and secure the Trim Switch assembly to the angle plate
using the three larger philips head screws (C) you removed
previously.
6) Reinstall the Steering Wheel. Installation is the reverse of
removal.
Installation With Offset Plate:
The installation procedures below outline installing either angle plate along WITH
the optional offset plate described in the Steering Wheel Offset Plate Installation
section on the previous page. Complete steps 1 and 2 above before proceeding.
'R' and 'L' are molded into the angle plates to differentiate them. The 'R' angle plate will angle the Steering Wheel toward the
Right and the 'L' angle plate will angle the Steering Wheel toward the Left.
3) Choose which angle plate you want to install, then feed the connectors from the Trim
Switch assembly through the angle plate and on through hole in the offset plate. Very
carefully plug the connectors into the matching connectors in the transmitter*.
B
B
C
D
E
OPTIONAL STEERING WHEEL ANGLE PLATE INSTALLATION GENERAL
There are small notches on the back side of
each of the parts that correspond to matching tabs on the Front side of each of the parts and the transmitter to ensure
everything is installed in the correct orientation.
*Do not install the offset plate onto
the transmitter before plugging the
connectors together, otherwise
the connector leads won't be long
enough.
Installation Without Offset Plate:
The installation procedures below outline installing either angle plate WITHOUT the optional offset plate described in the
Steering
Wheel Offset Plate Installation section on the previous page. Complete steps 1 and 2 above before proceeding.