User's Manual Part 2

MT-4S 2.4GHZ FH4T RADIO SYSTEM USER'S GUIDE

T R

[[ProGraMMinG MenuS

SteP (SteP auXiliary), Continued....

Point (Point auXiliary)

The Point Auxiliary function allows you to program the Auxiliary 1 servo to move up to 6 different Points along its travel,

then cycle through those Points using one of the Trim Switches or the Rotary Dial. For example, if your model requires

Adjusting the Step Auxiliary Value

1) From the TOP screen, press the ENTER key to open the Programming Menu list.

2) Scroll UP or DOWN to highlight the AUX1 menu, then press the ENTER key. The

3) Press the ENTER key, then scroll UP or DOWN to change the Auxiliary 1 Position

value. Increasing the value toward the High side (H) or Low side (L) will cause

the Auxiliary 1 servo to travel to that specific position when you Activate the Auxil-

AUX1 STEP AUX1 POSI setting range is H100 to L100. The default setting is 0. This

value is a percentage of Auxiliary 1 servo travel.

2) Scroll UP or DOWN to highlight the SYSTEM menu, then press the ENTER key.

Scroll DOWN to highlight the AUX TYPE menu, then press the ENTER key.

3) Press the ENTER key, then scroll UP or DOWN to choose the AUX 1: STEP AUX

Choosing the Step Auxiliary Function

Use one of the four Trim Switches or the Rotary Dial to cycle through the Point positions while you're driving. The

Point Auxiliary function can be toggled OFF and ON while you're driving by assigning Auxiliary 1 to one of the two

2) Scroll UP or DOWN to highlight the SYSTEM menu, then press the ENTER key.

Scroll DOWN to highlight the AUX TYPE menu, then press the ENTER key.

3) Press the ENTER key, then scroll UP or DOWN to choose the AUX 1: POINT AUX

Choosing the Point Auxiliary Function and the Number of Points

Controlling the Step Auxiliary Function

1) In the default configuration, Auxiliary 1 is controlled by the Rotary Dial which allows the Step Auxiliary function to be

adjusted while driving without accessing the Programming Menu. Turn the Rotary Dial clockwise to increase the Posi-

tion High Side value and turn the Rotary Dial counter-clockwise to increase the Position Low Side value. In addition,

Auxiliary 1 can be assigned to one of the four Trim Switches or the Auxiliary Lever. The Step Auxiliary function can

be toggled OFF and ON by assigning Auxiliary 1 to one of the two Push-Button Switches. This allows you to control