User's Manual Part 2

T R

MT-4S 2.4GHZ FH4T RADIO SYSTEM USER'S GUIDE

[[ProGraMMinG MenuS

Controlling the Step Auxiliary Function

1) In the default configuration, Auxiliary 2 is controlled by the Rotary Dial which allows the Step Auxiliary function to be

adjusted while driving without accessing the Programming Menu. Turn the Rotary Dial clockwise to increase the Posi-

tion High Side value and turn the Rotary Dial counter-clockwise to increase the Position Low Side value. In addition,

Auxiliary 2 can be assigned to one of the four Trim Switches or the Auxiliary Lever. The Step Auxiliary function can

be toggled OFF and ON by assigning Auxiliary 2 to one of the two Push-Button Switches. This allows you to control

SteP (SteP auXiliary), Continued....

Point (Point auXiliary)

The Point Auxiliary function allows you to program the Auxiliary 2 servo to move up to 6 different Points along its travel,

then cycle through those Points using one of the Trim Switches or the Rotary Dial. For example, if your model requires

Use one of the four Trim Switches or the Rotary Dial to cycle through the Point positions while you're driving. The

Point Auxiliary function can be toggled OFF and ON while you're driving by assigning Auxiliary 2 to one of the two

2) Scroll UP or DOWN to highlight the SYSTEM menu, then press the ENTER key.

Scroll DOWN to highlight the AUX TYPE menu, then press the ENTER key.

3) Press the ENTER key, then scroll UP or DOWN to choose the AUX 2: POINT AUX

Choosing the Point Auxiliary Function and the Number of Points

4) From within the AUX TYPE menu, scroll DOWN to highlight [MODE] 6 POINT.

Press the ENTER key, then scroll UP or DOWN to choose the desired number of

AUX TYPE POINT setting range is 2point to 6point. The default setting is 6point.

Adjusting the Point Auxiliary Values

1) From the TOP screen, press the ENTER key to open the Programming Menu list.

2) Scroll UP or DOWN to highlight the AUX1 menu, then press the ENTER key. The

3) Scroll UP or DOWN to move the brackets to the Point you would like to change,

then press the ENTER key to highlight that Point.

4) Press the ENTER key, then scroll UP or DOWN to change the Point value. Increas-

ing the Point value toward the High side (H) or Low side (L) will cause the Auxil-

iary 2 servo to travel to that specific position when you cycle through the various

Points.

AUX2 POINT setting range is H100 to L100. The default setting for Point 1 is L100, for Point 2 is L60, for Point 3 is L20,

for Point 4 is H20, for Point 5 is H60, and for Point 6 is H100. These values are a percentage of Auxiliary 2 servo travel.