User's Manual Part 2

MT-4S 2.4GHZ FH4T RADIO SYSTEM USER'S GUIDE

T R

The Binding function allows you to 'Bind' the transmitter and receiver pair. When new, it is necessary to pair the transmitter and

receiver to prevent interference from transmitters operated by other users. This operation is referred to as 'Binding'. Once the

Binding process is complete, the setting is remembered even when the transmitter and receiver are turned OFF. Therefore, this

procedure usually only needs to be done once.

Under some circumstances, the receiver may not operate after turning the transmitter and receiver ON. If this occurs,

perform the Binding process again.

Before beginning the Binding process, connect your servos and receiver battery pack to the receiver. For more information,

see the

Receiver Connections and Mounting

section on page XX. The transmitter and the receiver should be turned OFF.

4) While holding down the Bind Button on the receiver,

turn the receiver ON. The Bind LED on the receiver will

flash slowly. After approximately 2 seconds, release the

Bind Button. The Bind LED on the receiver will continue to

flash slowly.

Transmitter and Receiver Binding:

1) Turn the transmitter ON. The TOP screen will be displayed. Press the ENTER key (Push-Button Rotary Dial) to open the

Programming Menu list, then scroll UP or DOWN to highlight the SYSTEM menu.

5) Press the ENTER key. The [ENTER] command will begin to flash and the Bind LED on

the receiver will flash rapidly, then go out.

6) After the Bind LED on the receiver goes out, press the ENTER key a second time. The Bind LED on the receiver will illuminate

solid blue and LED 2 on the transmitter will go out, indicating that the Binding procedure is complete and a Telemetry

connection has been made.

Verify that the Modulation is set to [RF MODE]: FH4T is displayed an that the Servo Operating Mode for each channel is set

to NOR. If it isn't, change the Modulation Type to FH4T. If you need to change any of these settings, see the

BIND Menu

section on pages XX through XX.

3) Scroll UP or DOWN to highlight the [ENTER] command. Do not press the ENTER key yet.

7) Move the steering wheel and throttle trigger to verify that the servos are operating normally, then press and HOLD the

Back/Cancel key to return to the TOP screen.

When the Binding procedure is successful, the Bind LED on the receiver and LED 1 on the transmitter will illuminate solid

blue. If the Bind LED on the receiver is flashing rapidly or is not illuminated at all, the transmitter and receiver are not

paired. In this case, turn both the transmitter and receiver OFF, then repeat the Binding procedure again.

bInDInG THE TRAnSMITTER AnD REcEIvER

GEnERAl

IMPORTANT: This section details Binding the RX-472 4-Channel 2.4GHz FH4T Super Response receiver with the Servo

Operating Mode set to Normal mode. If you are Binding an FH2 or FH3 receiver, or if you prefer to change the Servo Operating

Mode, see the

BIND Menu

section on pages XX through XX.

2) Press the ENTER key to open the SYSTEM menu, then scroll DOWN to highlight the

BIND menu. Press the ENTER key to open the BIND menu.

You must complete step 5 below within 10 seconds or the Bind LED will go out, indicating the receiver has timed out. If

this occurs, turn the receiver OFF, then repeat step 4.