User's Manual Part 2

MT-4S 2.4GHZ FH4T RADIO SYSTEM USER'S GUIDE

T R

rPM SettinG (rPM teleMetry diSPlay oPtionS), Continued....

Calibrating the RPM Sensor

When you choose to use the RPM Sensor to display MPH or KM/H, the RPM Sensor must be calibrated to ensure that

3) From within the RPM menu, scroll UP or DOWN to highlight 10COUNT DIST.

12.0in (or 10COUNT DIST. 30cm).

4) Press the ENTER key, then scroll UP or DOWN to change the 10 Count Distance

value to the measurement obtained in step 2 above. For example, if your mod-

1) With the MT-4 2.4GHz FHSS-4T radio control system turned ON and the RPM Sensor installed on your model as de-

scribed in the Mounting the RPM Sensor section page 13, place your model on the ground.

2) Measuring from where you set your model on the ground, push your model and measure the distance covered to

When the reflective tape attached to your model's clutch bell, flywheel, etc., crosses the RPM sensor, the Bind

IMPORTANT: Prior to Calibrating the RPM Sensor, you must connect the RPM Sensor to the receiver and correctly

install the RPM Sensor onto your model. For more information, see the Mounting the RPM Sensor section page 13.

TELEMETRY 10COUNT DIST setting range is 0.5in to 118.0in (1cm to 300cm). The default setting is 12.0in (30cm).

RPM Sensor calibration is only required if you choose to use the RPM Sensor to display MPH or KM/H. Calibration

teleMetry SettinG (teleMetry and teleMetry loG oPtionS)

The Telemetry Setting allows you to choose whether the Telemetry System is turned ON or OFF and change the interval

3) Press the ENTER key, then scroll UP or DOWN to change the Telemetry ON/

OFF value. When ON is selected, the Telemetry System is turned ON. When OFF is

TELEMETRY SETTING ON/OFF setting range is ON or OFF. The default setting is

Turning the Telemetry System ON and OFF

1) From within the TELEMETRY menu, scroll UP or DOWN to highlight TELEMETRY

SETTING.

2) Press the ENTER key. The SETTING menu will be displayed and ON/OFF ON

SySteM MenuS

Adjusting the 10 Count Distance value will change the Maximum Speed value you changed in the previous step.

If the Telemetry Log function is started when the Telemetry System is OFF, default values will be stored in the