Installation Instructions

18
How to Use Each Feature
5
)
When deciding the car type using Enter, the screen changes to
Initialization (Model Initialization) screen.Do initialization following
the message.
6
)
When initializing (Initializing Model) is completed, the screen
changes to RF Mode Selection Screen.
MT-5 is only compatible FH5 RF mode.
○
Default: FH5
・
Compatible Receivers: FH5
RX-491,RX-492,RX-493,RX-493i
7
)
Once RF Mode for the receiver is determined, the screen
changes to the Response Mode screen. Set Response Mode
according to the servos and the equipment to be used.Set with
Up key/Down key and finalize with the Enter key.
○
Setting Range: NOR(Normal / Analog Servo)
SHR(High Response / Digital Servo)
SSR(Super Response / SRG Servo)
SUR (Ultra Response / PGS Servo)
○
Default: NOR(Normal / Analog Servo)
*In case of unknowing the device compatible response mode,
please set NOR.
*If using connected devices with wrong response mode, the
devices might be glitch or broken.
8
)
When Response Mode setting is completed, the screen changes
to BIND Set up Screen. Follow the screen message and start
Binding.
9
)
When Binding (BIND) is done, the screen changes to the Base
Set Up screen. Complete setting for each channel (refer to P. 26-
28).
10
)
When Base setting is done, Set Up Wizard will end. If you press
the Enter button, the screen changes to the Top screen.
IMPORTANT
• Please note that the analog servos do not work in SHR/SSR/SUR modes. If you mistakenly use the analog servos in
SHR/SSR/SUR mdoes, it does not work normally and the servos will be broken. Never use analog servos in SHR/SSR/
SUR modes. For digital servos (SRG, ERB, ERS Series and Digital ERG Series), either NOR or SHR mode works.
• SSR mode works only for PGS, SRG Servos, SUPER VORTEX/SV-PLUS series, HV-12, STOCK SPECIAL and HV-01.
• SUR mode works only for PGS servo, SUPER VORTEX Gen2 / PRO / SV-D2.
• With SHR/SSR/SUR mode, BL-RACER, BL-FORCE, F2000, F2200. F3000 F3300, SBL-01 02 and 03CL do not work.
Make sure to use them in NOR mode.
• BL-SIGMA, SV-08, HV-10, HV-12 and F2500 work in NOR/SHR modes.
ENTER BACK
ENTER BACK
ENTER BACK
ENTER BACK
• Please read user manual of using speed controller.