Installation Instructions

29
How to Use Each Feature
How to Use Each Feature
●
For Trim, you can adjust Trim for each channel and set the Trim action (center/parallel).
●
Correct neutral (center) of each channel (ST/TH/AUX1/AUX2) with Trim.
●
As default, steering is set for Trim 1 (TRM1), and throttle for Trim 2 (TRM2).
1) Select a channel (ST/TH/AUX1/AUX2) for
adjusting Trim with the Select button.
2) Determine with Enter operation and adjust
with the multi-selector.
○
Setting Range:
ST:L100
～
R100
TH:H100
～
B100
AUX1:H100
～
L100
AUX2:H100
～
L100
○
Default:

ALL : 0
*Make an adjustment with TRM1 (ST) and TRM2 (TH)
during operation.You can change the Trim lever position
with the Key Assignments Trim feature (P. 52).
Setting SUB-T
Trim2
Trim1
• About Trim
Trim is a feature to adjust the neutral (center) position of the servos. After installing
the steering servo onto a car, you can adjust with Trim when the car does not move straightly. Neutral
position adjustment is necessary not only after installing the servo but for changes that happen
during running such as tire wears and chassis twist.
• It's Sub Trim that adjusts het center position when adjusting linkage (P. 26)
Note
• If Trim and Sub Trim are off to one side, it causes dead band (the range the servo does not
move) to the steering wheel and the throttle trigger. When installing the servo horn, fix the
servo horn as close to the center as possible and center it with Sub Trim.
IMPORTANT
●
You can set Trim performance of each channel to Center Trim (CENT) and Parallel (PARA).
●
As default, steering is set for Trim 1 (TRM1), and throttle for Trim 2 (TRM2).
1) Select a channel (ST/TH/AUX1/AUX2) to set with the Select button.
2) Determine with Enter operation and adjust
with the multi-selector.
○
Setting Range:CENT(Center Trim)/PARA(Parallel Trim)
○
Default:CENT(Center Trim)

Selecting a channel with the select button
• About Center Trim and Parallel Trim
There are two types of Trim including Center Trim that adjusts only the neutral position without changing
the end of the operating angle and Parallel Trim that moves the end of the operating angle and the neutral
position simultaneously. Sub Trim that adjusts the neutral (center) position before fixing the servo horn is
Parallel Trim and the main trim has options of Center Trim and Parallel Trim. You can select according to
your purpose.
○
Center Trim
Even if you move the neutral position with Trim,
the end of the operation angle does not move.
○
Parallel Trim
When you move the neutral position with Trim,
the end of the operation angle also moves.
When Sub Trim is adjusted after linkage
is completed,readjustment of End Point
Adjustment (EPA) will be necessary.
IMPORTANT
TRIM
SETTING
TRIM
TRIM TYPE