Installation Instructions

32
How to Use Each Feature
●
By moving the position of the throttle neutral at the time of starting a nitro RC car engine, it improves the
start-up performance of the engine.
●
You can fix at a position where idling speed is increased so that the engine will not stop during refueling
your nitro RC car.
●
By operating the switch that has been set, you can stop the engine of your RC boat.
●
You can use various power sources with Offset feature.
●
ON/OFF of the Offset feature is not assigned to the switch
and keys at the factory. When using, assign the features
with key assignment (P. 51, 52).
1) Select the throttle function with the multi-selector and
determine with the Enter operation.
2) Select [OFFSET] with the multi-selector and determine
with Enter. It will change to OFFSET Setting menu.
3) Setting Offset [OFFSET]
Set ON/OFF of the Offset feature with the multi-selector.
○
Setting Range: ON/OFF
○
Default: OFF
4) Setting Type [TYPE]
Set Type of the Offset with the multi-selector.
○
Setting Range: I-UP (Idle Up)/N-BR (Neutral Brake)
○
Default: I-UP
5) Setting Point [POINT]
Set Point of the Offset with the multi-selector.
○
Setting Range: 0%
～
100%
○
Default: 0%
6) Setting Beep [BEEP]
Set Alarm (Beep) that goes of when the Offset is activated.
○
Setting Range: ON/OFF
○
Default: ON
*When the Offset feature is working, X illumination
and Function LED flash.
Servo Operating Quality
OFFSET Position
When setting plus
OFFSET Position
Neutral postion
When setting plus
Trigger Control Input
Neutral position
for Normal
OFFSET Position Neutral
positionwhen setting minus
OFFSET Position
When setting minus
ENTER BACK
●
You can move the neutrals position of the throttle and set the operating ratio of the forward side and the
brake (backward) side to either 7:3 or 5:5.
*Set the throttle type according to the speed controller to be used.
1) Select the throttle function with the multi-selector
and determine with the Enter operation.
2) Select [TH TYPE] with the multi-selector
and determine with Enter.
3) Setting the Throttle Type
Set the Throttle Type with the multi-selector.
○
Setting Range: F7:B3 / F5:B5
○
Default: F7:B3
*When changing TH TYPE, the screen changes to
the confirmation screen and a message is displayed.
Operate following the message.
ENTER BACK
OFFSET
THROTTLE FUNCTION
THROTTLE TYPE
[
TH TYPE
]
THROTTLE FUNCTION