Installation Instructions

36
How to Use Each Feature
●
Code AUX (CODE AUX) is a feature to perform code communication by assigning a setting value to each
code of CODE5/CODE10 It is an extension feature to change the setting of speed controller (SUPER
VORTEX series/ SV-D2), PGS servo series, and the Gyro System (SGS-01C/SGS01D/SGS-02) that are
compatible to CODE AUX.
●
You can set 2 types of Code AUX1 and CODE AUX2.
*Setting of CODE is done by setting [TYPE] of [SYSTEM] menu. By setting [MODE], the display is
changed according to each equipment. When setting [MODE] to [USER], each code display allows the
user to set.
*When using an AUX channel as CODE AUX, make sure to set the response mode of A1/A2 that are set
for BIND to [SHR] (See P.49, 50).
*When using CODE AUX, do not connect the servo to CH3 and CH4 ofthe receiver to be used.
*When using, assign the features to Dial or Trim with the Key assignments or operate with the multi-
selector.
1) Select [AUX] with the multi-selector and define
with the Enter operation.
2) Setting Code AUX
Select [CODE AUX] to change setting and
adjust the setting value with the multi-selector.

○
Setting Range: -100%
～
100%
○
Default: 0%
*In case of setting CODE5/CODE10 on AUX TYPE, CODE AUX
setting condition will display on top screen as below pictures.
*Please check CODE5/CODE10 compatible devices on SANWA HP.
Please check each compatible device user manual about
detail setting for the each device.
ENTER BACK
When TYPE setting is [CODE10]
and MODE setting is [SV-G/D]
When MODE setting is [USER]
When TYPE setting is [CODE5]
and MODE setting is [SVZ]
When MODE setting is [USER]
CODE1 Parameter
CODE3 Parameter
CODE2 Parameter
CODE4 Parameter
CODE5 Parameter
+100 ‑1000
CODE7 Parameter
CODE8 Parameter
CODE10 Parameter
CODE9 Parameter
CODE6 Parameter
AUX TYPE = When setting is CODE AUX, bar display
CODE AUX
AUX