Installation Instructions

38
How to Use Each Feature
5) Setting START
Set the Timer Start from the Trigger Interlock/Switch/Random.
○
Setting Range: TRIGGER/KEY/STARTER
○
Default: TRIGGER
6) Setting DATA-LOG
It sets Telemetry Data Log (record) along with the timer.
○
Setting Range: ON/OFF
○
Default: ON
*Log starts along with the timer feature.
Function LED
X Illumination
LED flashes while the timer is activated.
●
You can measure and record each lap up to 999 laps (works for all models).
●
Pre Alarm (PRE-ALM) is installed and the alarm goes off before the goal.
1) Select [TIMER] with the multi-selector and determine with the Enter operation.
2) Starting the Timer
As a default, the timer switch is set to SW1. By holding SW1, the timer becomes a standby state for
starting and by either pressing SW1 again or operating the throttle trigger, measuring starts.
3) Every time you operate SW1, lap time is measured.
The switch does not work for 3 seconds after operating SW1.
4) Completing measuring
By holding SW1, measuring will be completed.
*You can check the measured lap time on the LAP TIMER screen.
When Enter is being operated while the lap timer is
activated/stopped on the LAP TIMER screen, the screen is changed
to the lap time display. You can check each lap time with the
multi-selector operation (not possible on the SETUP screen).
*When turning the power switch off while the timer is activated,
the timer will be reset.
*When the timer is set to SW1/SW2, the timer will be in
the standby mode by holding the switch even on a screen
other than the setting screen.
Switch 1
ENTER BACK
ENTER BACK
LAP TIMER
TIMER