Installation Instructions

49
How to Use Each Feature
How to Use Each Feature
●
Select the output system that suits the receiver, set a mode for
the servo (analog/digital) and the speed controller to be used
and bind the transmitter with the receiver.
When using first time, please bind with receiver.
1) Select [SYSTEM] with the multi-selector and determine with the
Enter operation.
2) Select [BIND] with the multi-selector and determine with the
Enter operation.
3) Setting RF MODE (Signal output system)
○
Output System
・
FH5
RX-491,RX-492, RX-493, RX-493i
*FH4, FH3, FH2, FH-E, DS mode receivers are not compatible
with MT-5.
4) Setting TELEMETRY
Set TELEMETRY with the multi-selector.
○
Setting Range: ON/OFF
○
Default: ON

*Telemetry Compatible Equipment
RX-491,RX-492, RX-493, RX-493i
*Re-BIND is necessary if setting is changed.
5) Setting SAFETY LINK
Set SAFETY LINK (Safety Link) with the multi-selector.
○
Setting Range: 01
～
50
○
Default: 01
*When changing the setting of SAFETY LINK after BINDING,
BIND again.
*Recommend to bind each car and receiver with different safety
link number. In case of selecting wrong model, this can be
avoiding misoperation or misworking.
Confirmation Screen
ENTER BACK
ENTER BACK
Output System
Response Mode
●
A feature for setting system of the transmitter, such as Bind (BIND), Key Assignments (KEY ASSIGN),
BUZZER (Buzzer), Battery (BATTERY), LCD and CALIBRATION (Calibration).
SYSTEM MENU
SYSTEM
BIND