Installation Instructions

51
How to Use Each Feature
How to Use Each Feature
Positions of the Switch and Trim
TRIM1
TRIM2
TRIM4
DIAL
TRIM3
SWITCH2
PUSH SWITCH1
Features assgined to the Switch and
Trim at the factory
TR1:Steering Trim(TRM-ST)
TR2:Throttle Trim(TRM-TH)
TR3:Dual Rate ST(D/R-ST)
TR4:Dual Rate BR(D/R-BR)
SW1:Timer (TIMER)
SW2:CUSTOM
●
You can assign features to the switches (SW1, SW2, SW3) of the
transmitter and toggle ON/OFF of the features during operation.
1) Select [SYSTEM] with the multi-selector and determine with the
Enter operation.
2) Select [KEY ASSIGN] with the multi-selector and determine with the
Enter operation.
3) Setting the Switch (SW1/SW2)
Operate the Enter with [SW] and set the feature to assign to the
switch with Up key/Down key.
○
Default : SW1: TIMER SW2: CUSTOM
*BY Setting [ASSIST-ST] onto SW1/SW2, you can turn ON/OFF
the feature of D/R, SPEED and CURVE that can be set onto the
steering.
4) Setting Mode
It sets the switch performance but there are casesthat youcannot set
depending on the feature to assign.
○
Setting Range
TOGGLE (Switching between ON/OFF when pressed every time)
PUSH (ON only during being pressed)
Tips
*Please set TOGGLE when assigned ALB function on SW2.
*In case of assigned TOGGLE, ALB switches ON and OFF when
pushing SW2.
*ALB setting is not working only for setting ON at ALB function (p.31)
ENTER BACK
ENTER BACK
Switch
SW1
SW2
An assignable feature
OFF, ASIST-ST, D/R-ST, D/R-TH, D/R-BR, CUR-ST, CUR-TH, SPD-
ST, SPD-TH, ALB, OFFSET, AUX1, AUX2, TIMER, MAX-CLR,
R-MODE, CUSTOM
SYSTEM MENU
SYSTEM
KEY ASSIGN SWITCH