Installation Instructions

52
How to Use Each Feature
●
You can change the setting value of each feature with Trim1 - Trim4.
●
You can also change the setting of the variation change in one time of Trim operation with the STEP
setting and the direction of the action with the REV setting.
TRIM
TRIM1
TRIM2
TRIM3
TRIM4
An assignable feature
OFF, TRIM-ST, TRM-TH, TRIM-A1, TRIM-A2, D/R-ST, D/R-TH, D/R-BR,
CU-R-ST, CU-R-TH, CU-R-BR, SP-ST-F, SP-ST-R, SP-TH-F, SP-TH-R,
ALB-PO, ALB-ST, ALB-LG, ALB-CY, OFFSET, AUX1, AUX1(CODE1
～
10), AUX2, AUX2(CODE1
～
10)
KEY ASSIGN TRIM
1) Select [SYSTEM] with the multi-selector and determine with
the Enter operation.
2) Select [KEY ASSIGN] with the multi-selector, switch to
[TRIM] with the Select button, select an item to set and
determine with the Enter operation.
3) Setting Trim (TRM1/TRM2/TRM3/TRM4)
Select [TRIM] to change the setting and set a feature to
assign with the multi-selector.
○
Setting Range:
○
Default: TR1:TRM-ST
TR2:TRM-TH
TR3:D/R-ST
TR4:D/R-BR
4) Setting Step
Set the variation of the movement by one-time Trim operation. Select [STEP] with the multi-selector,
determine with the Enter operation and set the variation.
○
Setting Range: 1
～
100
○
Default: 5
5) Setting the Direction of Action
Set the direction of action when operating Trim. Select [REV] with the multi-selector, determine with the
Enter operation and set the direction of action.
○
Setting Range: NOR/REV
○
Default: NOR
About Dial
*Assigned on Dial also can set as same as assigned TRIM.
*In case of setting GAIN on assigned Dial, please select AUX1 or AUX2 to assign Dial.
*If setting STEP MODE is 1 on AUXTYPE, value can be set 1 each when turing Dial. (Defaul MODE
setting is 5, so values set 5 each in default setting when turing Dial)
*Please refer to CODE AUX compatible device user manual when setting CODE AUX and select
assigned function.