Installation Instructions

Before Using

MT-5 can change a grip pad from two types of normal/small to suit the size of the user’s hand.

(The normal size is installed at the factory.) Do not pull forcefully because it’s locked to the grip of the transmitter with

tabs of the grip pad (at 11 locations).

MT-5 can adjust the tension of the steering/throttle trigger to match operation of the steering/throttle to the user’s preference.

By inserting a hex wrench driver (1.5mm) to the place where the

arrow is pointing at in the illustration on the right and turning, you

can adjust the tension of the steering spring.

*The spring tension is the softest at the time when the product

is shipped out from the factory. As you tighten with a hexagon

wrench driver (1.5mm), the spring tension will be hardened.

By inserting a hex wrench driver (1.5mm) to the place where the

arrow is pointing at in the illustration on the right and turning, you

can adjust the tension of the throttle spring.

*Please do CALIBRATION for steering and throttle when

changing the tention. (p.59)

Tabs

(11 locations)

Grip Pad

(Normal)

Grip Pad

(Small)

ADJUSTING THE STEERING AND THROTTLE TENSION

ADJUSTING THE GRIP PAD

Adujsting the Steering Tension

Adjusting the Throttle Trigger Tension