Installation Instructions

7
Before Using
Before Using
7
Fixing screw of the trigger
Adjusting screw for
the trigger postion
Trigger position gauge
Adjustable range: approx. 5mm
Angle spacer
Installed at the factory
Angle spacer
Angle spacer
Fixing screw of the trigger
Loosen the fixing screws of the trigger on
the back of the transmitter. Then, adjust the
adjusting screw of the trigger position on the
back of the transmitter to set the trigger at
the position of your preference. When you
turn the adjusting screw of the trigger position
clockwise, the trigger position gauge moves to
the direction A. By turning it counter clockwise,
the trigger position gauge moves to the
direction B.
*The range of the trigger movement is 5mm.
If you turn the screw forcefully beyond the
range, it can cause malfunction. Once you set
the trigger position, tighten the fixing screw
and adjusting the trigger is done.
*Be careful with the direction of turning the
screw because the trigger position is set at the
furthest point of the A side at the factory.
Adjusting the trigger position
Adjusting the trigger angle
By switching the angle spacer A/B/C, it is
possible to adjust the angle of the throttle
trigger to five steps.
1
)
Remove the fixing screw of the trigger on
the back of the transmitter.
2
)
Adjust the angle by changing the direction of
the angle spacer to have an angle easy to
operate.
3
)
Once the trigger angle is set, fix the fixing
screw of the trigger on the back of the
transmitter.
ADJUSTING THE FULL ADJUSTABLE TRIGGER