Installation Instructions

8
Before Using
You can adjust brake trigger position
accroding to your fingers by replaceing the
included brake trigger.
Standard Size, +1 Size, +2 Size is included.
1
)
Remove the brake trigger fixing screw.
2
)
Select Brake Trigger according to your
fingers.
3
)
Fix the brake trigger by the screw.
Brake trigger fixing screw
(+1)
(+2)
●
MT-5 is compatible to Micro SD Cards. By using a Micro SD Card, it is possible to save model data and
telemetry data. Also, it is possible to do firmware update using a Micro SD Card when a firmware update of
MT-5 is released. Please take care of direction. Metal terminal shoud be bottom.
●
After inseting micro SD card into MT-5, the file named “MT-5” is made and the folder named “MODEL” is
made. The model data is saved in the folder. If the log data is exported, the folder named “Log” is made
and the data named “csv” is saved in the folder.
*Compatible Micro SD card capacity is maximum 32GB. Other manufacture Micro SD card might not be
able to use. Please use Micro SD card by SANWA.
micro SD cover
When micro SD card is inserted, this mark will be on.
Connector Cover
Adjusting the brake trigger
●
When using an optional battery, you can access to the charging port on the side of the battery from the
connector cover.
ABOUT THE POWER SOURCE
ABOUT MICRO SD CARD
HOW TO PLACE THE TRANSMITTER BATTERIES
ABOUT THE OPTIONAL BATTERY
<1>Open the battery
compartment cover by sliding
the cover to the direction of the
arrow while pressing it lightly.
<2>Place 3 size AAA
batteries. Make sure to
observe correct polarities.
<3>Align the convex part of the
battery compartment cover and the
groove of the battery compartment,
slide the cover to the direction of
the arrow and close tightly.