User's Manual

Ringer switch
The RINGER switch must be on for the handset to ring during
incoming calls.
Volume adjustment
The VOLUME keys adjust the volume level of the earpiece.
1. Make sure the phone is ON (handset is in use).
2. Press the VOLUME ▲ or ▼ key on the side of the handset.
The volume level shows on screen.
Pre-dialing
1. Make sure the phone is OFF (not in TALK mode).
2. Enter the telephone number. The telephone number shows on
screen.
3. Press TALK/CALL BACK. The telephone number shows on the
respective screen.
Note: You may enter up to 32 pre-dial digits.
Changing the pre-dial number
1. Make sure the phone is OFF (not in TALK mode).
2. Enter the telephone number.
3. Press REDIAL/DEL to delete digits one by one.
4. Re-enter the number.
Redialing
1. Make sure the phone is OFF (not in TALK mode).
2. Press TALK/CALL BACK.
3. Press REDIAL/DEL to redial the last number (up to 32 digits).
Fast redialing
1. Press TALK/CALL BACK.
2. Enter the telephone number you want to dial.
If the line is busy, press REDIAL/DEL. The phone will drop the
line for two seconds and redials the number.
FLASH key
Use the FLASH/PROGRAM key to activate custom calling services
such as Call Waiting or Call Transfer, which are available through your
local phone company.
11
10
1. Make sure the phone is OFF.
2. Press FLASH/PROG until
DDEEFFAAUULLTT SSEETTTTIINNGG 11YYEESS 22NNOO
shows on screen.
22NNOO
is factory set.
3. Press CID ▲ or ▼, or the 1 or 2 key to select your choice.
4. Press FLASH/PROG to confirm.
BASICS
INITIAL PROGRAMMING
BASICS
Receiving a call
When an incoming call is received, handset LCD screen lights and
shows caller information*. The incoming call LED on the handset
flashes.
* A subscription is required from your local phone company to receive
Caller ID information on your phone. See Caller ID Features, page XX.
1. Press TALK/CALL BACK to answer the call.
Note: If handset is in the base cradle, remove it from base before
pressing the TALK/CALL BACK key.
2. Press TALK/CALL BACK again to hang up.
Note: If you replace the handset to the base cradle, the handset
automatically hangs up.
Making a call
1. Press TALK/CALL BACK.
Note: If handset is in the base cradle, remove it from base before
pressing the TALK/CALL BACK key.
2. Dial the phone number.
The screen shows the number as you enter.
3. Press TALK/CALL BACK again to hang up.
Telephone number
Channel No. Call timer Volume level
BASICS
CLT-2412E-NEW 7/5/02 6:21 PM Page 10