User's Manual

7
Use the projector properly in specified positions. Improper positioning may reduce the lamp life and result in severe
accident or fire hazard.
This projector can project the picture upward, downward, or backward, perpendicular to the plane of the screen as
shown in the figure below.
Bottom
Downward
(Usual)
Front
Downward
Bottom
Upward
Front
Upward
Installing the Projector in Proper Directions
Avoid positioning the projector as described below when installing.
Positioning Precautions
Do not roll the projector more than 10 degrees from side to side.
Do not put the projector on either side to project an image.
Û
Û
10Û0
Û
10Û
10
Û
In upward projection, do not tilt the projector over 10 degrees right and left.
In downward projection, do not tilt the projector over 10 degrees right and left.
Safety Instructions
0º
90º
180 º
40º
50º
140º
50º
40º
Be sure to set the Lamp control in High and the Fan control in On 3
in the setting Menu when using the projector inclined at between +40
degrees to +140 degrees to the horizontal plane at altitudes between 0
and approximately 1,600 meters above sea level.
Be sure to set the Fan control in On 2 when using the projector at higher
altitudes than the altitudes described above, regardless of the installation
position of the projector. (p.52)