User's Manual

18
The preparation display will disappear after 30 seconds.
(See page 54 for Lamp control status.)
Turning On the Projector
Connect the projector’s AC power cord into an AC
outlet. The POWER indicator lights red. Open the lens
cap (pp.8, 62).
Press the ON/STAND-BY button on the top control or
on the remote control. The POWER indicator lights
green and the cooling fans start to operate. The
preparation display appears on the screen and the
countdown starts.
2
3
1
4
After the countdown, the input source that was
selected the last time and the lamp control status icon
(p.54) appear on the screen.
Complete peripheral connections (with a computer,
VCR, etc.) before turning on the projector.
Selected Input Source and Lamp Control
 Note:
 •WhentheLogoselectfunctionissettoOff, the logo will
not be shown on the screen (p.48).
 •WhenCountdown off or Off is selected in the Display
function, the preparation display will not be shown on
the screen (p.48).
 •WhentheInputSearchfunctionissettoOn 2, the input
signal will be searched automatically (p.47).
 •When Off is selected in the Display function, the Video/
PC selection window and the input signal guidance
window are not shown on the screen (p.48).
 Note:
•The Filter warning and Lamp replacement
icons may appear on the screen
depending on the usage state of the
projector.
Basic Operation
Lamp control status
If there is no signal input when start on the projector,
or the current signal is missed while operating the
projector, the Video/PC selection window will be
displayed on the screen, please move the pointer to
input source desired by pressing the Point ▲▼ buttons
and press the SELECT button. And then follow the
input signal guidance window to correct the signal and
connection.
If the projector is locked with a PIN code, PIN code
input dialog box will appear. Enter the PIN code as
instructed on the next page.
5
Video Selection
PC Selection
Guidance for PC Input
Guidance for Video Input
16
http://www.eiki.com