User manual

After the lens replacement, check the following things.
1. Check the lens is properly installed.
2. Check no wiring is tangled on the gear of the lens motor or other mechanical
parts.
3. Check no parts is missing, or no mounting part is lost.
LCD Projector
Lens Replacement Procedure
Model Number
LNS-S11
¡ It should be followed by this procedure precisely.
¡ Before the lens replacement, turn off the projector and unplug
the AC power cord.
¡ Before an attempt to replace the lens, confirm the model num-
ber (both the LCD projector and the lens) and prepare the prop-
er lens.
¡ The lens caps are on the lens for protection. Be sure to remove
the lens cap before installation.
¡ Please avoid the lens replace in the place where a lot of dust
exists. It causes the image quality to be ruined when garbage
and dust enter the projector.
¡ When installing or removing the lens, be careful not to stain,
scratch or damage the lens.
¡ Ask the sales dealer for detailed information of the lens specifi-
cation.
Notes on Lens Replacement
Following part is contained in the packing.
● LENS 1 piece
Notes on Lens Replacement
Parts List
Printed in Japan
1AA6P1P5474-- (IFGM)
Lens Replacement Procedure
Remove the Lens
1
2
Perform the steps 1-2 for lens replacement.
First set the lens at the center position with lens shift adjustment.
Fig-1-1
LENS RELEASE BUTTON
Fig-1-2
Fig-2
Red mark
Mount the Lens
1. Remove the lens caps (front and back) on the lens.
2. Fit the lens to the projector by aligning the red dot
on the lens with the red dot of the projector.
3. Slowly turn the lens clockwise until it clicks. Make
sure that the lens is fully inserted to the projector.
While pressing the Lens release button on
the top of the cabinet, turn the lens counter-
clockwise until it stops and pull it out slowly
from the projector.
Be careful not to drop the lens.
LENS_IFGM_A3 07.10.31 9:44 AM ページ2