User manual

-ā8ā-
ELECTRONIC CONTROL RESET
Press the SEL button ➁ for about 3 seconds until the unit beeps, the audio controls, except for volĆ
ume, will be reset.
BASSXPANDER (BASX) - 1/2 4...........................
BASSXPANDER is a dual-mode sound equalization feature. Press button ➃ to select the BASSXPANDER
modes as follows;
b-1 b-2 OFF
BASSXPANDERoffers two preset modes:b-1enhances the low and highfrequencies,whileb-2enhances the
low frequencies and reduces the high frequencies.
RADIO SELECTION BUTTON (BAND) 5....................
Press the BAND button ➄ to switch from tape, CD player or CD changer mode to radio.
Each time the button is pressed, the function changes as shown below.
FMI FMII AM
TAPE SELECTION BUTTON ( ) 7......................
Press button ➆ to switch from radio, CD player or CD changer mode to tape mode.
CD PLAYER OR CD CHANGER* SELECTION BUTTON
(CD/CD-CH)
6...........................................
Press the CD/CD-CH button ➅ to switch from radio or tape mode to CD player or CD changer* mode.
* If a CD changer is connected.
Pressing the button will change the mode as follows:
1 When a CD is loaded in the CD player and a CD changer is not connected;
Radio/Tape CD player CD player pause
2 When a CD is not loaded in the CD player and a CD changer is connected;
Radio/Tape CD changer CD changer pause
3 When a CD is loaded in the CD player and a CD changer is connected;
Radio/Tape CD player CD changer
CLOCK BUTTON (DISP) 8.................................
Press the DISP button ➇ to switch between the clock and audio display. When an audio function is performed
while the time display is selected, the audio display will appear for 5 seconds, then the display will return to the
timemode.
TO CANCEL THE BEEP TONES 7.........................
1 Tocancel all beeptones,pressbutton ➆ for morethan 3 seconds withno tape in theslot, and then
is displayed.
2 To turn onthe beep tones again, perform the sameprocedure. The beep tones are set and is disĆ
played.