OPERATING INSTRUCTIONS FXCD-500 Full Panel Detachable FM Stereo/AM Receiver Auto Reverse Cassette Player Compact Disc Player with CD Changer Controller IS0 Mounting with Removable Trim Ring (English) OPERATING INSTRUCTIONS (Espafiol) LIBRITO DE INSTRUCCIONES 7 -30 31-59
SANYO MOBILE AUDIO MODEL FXCD-500 LIMITED WARRANTY OBLIGATIONS In order to obtain warranty service, the product must be delivered to and picked up from an Authorized Sanyo Factory Service Center at the user’s expense, unless specifically stated otherwise in this warranty The names and addresses of Authorized Sanyo Service Centers may be obtained by calling the toll-free number listed below.
CONTENTS COMPACT DISC CARE DIGITAL DISPLAY DETACHABLE FRONT PANEL GENERAL OPERATION RADIO OPERATION TAPE OPERATION CD OPERATION CD CHANGER OPERATION ERROR SIGNS CLOCK HINTS FOR PROPER AND SAFE OPERATION TROUBLESHOOTING ACCESSORIES AND HARDWARE INSTALLATION UNIT REMOVAL ELECTRICALCONNECTIONS LINE OUT/CD CHANGER CONNECTIONS SPECIFICATIONS 3 5 6 7 9 11 14 16 16 19 20 21 22 23 26 27 26 29 ACAUTION l l l l l l l l l This unit is designed to operate on 12 volts DC, NEGATIVE ground electrical systems only W
COMPACT DISC CARE Dirt, dust, scratches and warpage can cause a deterioration in the sound or intermittent skipping some tracks during play f l DIGITAL AUDIO l This unit has been designed to play compact discs bearing the identification logo shown onthe left Discs bearingothertypesofidentification logos may not play properly CD-R and CD-RW discs cannot be used \ J Do not use non-conventional discs such as heart-shaped, octagonal discs, etc The player could be damaged l l Label Side l l l ’ Fin
l ing spray l -4- Never use chemicals such as record cleaning sprays, antistatic sprays or fluids, benzene or thinner to clean compact discs These chemicals will permanently damage the plastic surface of the disc When not using the disc player for extended periods, remove the compact disc and return it to the plastic storage case This will protect the disc from dust and exposure to the sun
DIGITAL DISPLAY Automatic Music Select System (AMSS) Metal Display Auto Travel Preset (ATP) Tape playing direction Disc in BASSXPANDER Dolby Noise Reduction Disc Number FM Bands Radio Frequency, Time, CD Track Number, Audio Control Selection, Scan Play, Repeat Play, Shuffle Play, Error Signs, CD In (CD player and CD changer), CD Eject, Tape In, Tape Eject Preset Channel, Auto Travel Preset Channel *Dolby noise reduction manufactured under license from Dolby Laboratories Licensing Corporation “Dolby”
DETACHABLE FRONT PANEL The front panel is designed to be removable for antitheft purposes It is recommended that you remove and carry the front panel with you when you leave your car A carrying case is provided with the unit for this purpose HOW TO DETACH q q THE FRONT PANEL HOW TO REPLACE THE FRONT PANEL Align the right side of the panel with the stopper, and then push the left side of the panel into the unit until it clicks r RELEASEKNoB Press the release knob (REL) to release the front panel
GENERAL OPERATION 4 8 765 i 2 3 TURNING THE POWER ON install the front panel and press the ON/OFF button 0 when ACC is on TURNING THE POWER OFF . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Press the ON/OFF button 0 to stop the current operation The button dims when the power is off (ACC on) ELECTRONIC CONTROLS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ELECTRONIC CONTROL RESET Press the SEL button 0 for about 3 seconds ume, will be reset BASSXPANDER until the unit beeps, the audio controls, (BASX) - l/2 . . . . . . . . . . . . . . . . . . . . . . . . . . .
RADIO OPERATION \ I I I I I I I 3 SELECTING RADIO MODE Press the BND button 0 to switch from tape, CD or CD changer* mode to the radio Each time the BND button is pressed, the selected band changes as shown below * If a CD changer is connected FM1 - FM11 - AM RADIO TUNING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ATP (AUTO TRAVEL PRESET) OPERATION . . . . . . . . . . . . . .
TAPE OPERATION 109876 LOADING AND EJECTING THE TAPE Insert a cassette into the tape slot 0 and the tape player will start Press the eject button 0 to eject a tape The system will return to the last mode rn I CAUTION 5 Only cassette tapes that play no longer than 90 minutes should be used Tapes exceeding 90 minutes are thin and may easily break I SELECTING TAPE MODE lnsertingacassette into the tape slot as stated above will start the tape player If radio, CD player or CD changer* is in operation with
LOCATING THE BEGINNING OF A PROGRAM (AMSS) . . . .
SCAN MODE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Scan helps to find a program by playing about the first 10 seconds of each selection ’ Press the SCN button @ during play to start scan operation “sc ,-,” is displayed To cancel scan, press the SCN button @again RPTISCN may not operate properly if A tape was recorded at a low level A tape has long, silent intervals l l REPEAT MODE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CD OPERATION LOADING AND EJECTING THE CD . . . . . . . . , . , . . . . . . . . . . . 1, 2 insert a disc into the CD slot 0 and the CD player will start Press the eject button 0 to eject a disc pm CAUTION I l l This CD player is not designed for 8 cm CDs Please do not use an 8 cm CD nor 8 cm CD adaptor If the unit is already loaded with a CD, please do not attempt to insert another disc, which may result in damage to both of the discs and the unit SWITCHING TO CD MODE . . . . . . . . . . . . . . . .
SKIPPING Press the Press the Press the Pressand or reverse When the TRACKS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CD CHANGER OPERATION THE UNIT CAN BE USED TO CONTROL THE FUNCTIONS OF THE AX-300, AX-500 OR OTHER COMPATIBLE SANYO CD CHANGERS 1 54 67832 SELECTING CD CHANGER MODE . . . . . . . . . . . . . . 1 Press the CD/CD-CH button 0 to switch from radio, tape or CD player mode to CD changer mode Pressing the button will change the mode as explained in section “CD PLAYER OR CD CHANGER SELECTION BUlTON (CD/CD-CH)” in page 8 SELECTING A DISC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
REPEATMODE l l ........................................ Repeat tracks Repeat discs 7 Press the RPT button 0 to play the current track repeatedly Press the RPT button Ofor more than 2 seconds to play the current disc repeatedly To cancel the track repeat or disc repeat mode, press the RPT button 0 again The system will remain in this mode until it is cancelled SCAN MODE OF TRACKS (PLAYING OR DISCS) THE BEGINNING . . . . . . . . . . . . . . . . . . . . . . . . . ..m....
CD Player If a problem should may be displayed occur while operating Error Sign Jf J, J7 J,( CD player, one of the following Cause Abnormal mechanism function I 1 I Use another disc Leave the disc player off for an hour or so, then try again Internal connection check error CD Changer If a problem should occur while operating signs may be displayed Error Sign 1 the connected Cause Abnormal mechanismfunction The disc was inserted incorrectly The disc is dirty The disc is defective There is conden
CLOCK 1 32 DISPLAY MODE CHANGE The display on the unit can be changed clock and audio display When a radio, audio display will appear for 5 seconds, ADJUSTING ............................... 1 by pushing button 0 Press the DISP button 0 to switch between tape or CD function is performed while the time display is selected, then the display will return to the time mode CLOCK RESET l I l The time display blinks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
HINTS FOR PROPER AND SAFE OPERATION l l l l l l l Condensation Moisturecan condense on the optical lens of the CD player during humid or rainy days, or after the car heater is turned on If this occurs the disc player may not function properly To remedy the situation, remove the disc from the unit and wait approximately one hour This should allowthe moisture to evaporate and restore normal operation TemperatureConsideration Theunit may not operate correctly in extremely hot or cold temperatures high o
TROUBLESHOOTING Sometimes a simple operational error or a mistake in the wiring can appear to be a problem with the unit Before having the unit serviced, refer to the troubleshooting chart below Symptom Cause Solution The compact disc does not The volume control is Turn up the volume control play when inserted into the turned down unit The power connections are Check the +I 2V and ground not wired correctly connections No power The vehicle ignition is Switch the ignition to the “ON” or switched off “ACC” po
ACCESSORIES AND HARDWARE INSTALLATION Mounting Bracket (Half Sleeve) x 1 Rear Strap (Brace) x 1 Mounting MountingGrommet Xl SECURITY Screw OF FRONT PANEL Screw Screw M5 xl M5 x 14 x2 Hex bolt M8 x 6 x4 Removable SET REMOVAL M2 x 8 Xl Unlock Levers x2
INSTALLATION 1. BEFORE INSTALLATION When mounting the unit in a car, keep the unit as level as If the unit must be mounted at an angle, due to the design of the vehicle, make sure the unit does not tilt by more than 30” 2.
3.
2) Installation to TOYOTA/NISSAN Vehicles Install the unit using the existing TOYOTA/NISSAN Mounting Bracket and Screws Use the mounting holes in the unit chassis ‘7” or “N” is engraved next to each mounting hole Use 7” holes for Toyota vehicles and “N” holes for Nissan vehicles TOYOTA/NISSAN ONLY USE M8 x 6 SCREW (INCLUDED WITH THIS UNIT) AS ILLUSTRATED ABOVE USE OF ANY OTHER SCREW OR HARDWARE MAY RESULT DAMAGE TO HEAD UNIT Screw -7!i-
UNIT REMOVAL UNLOCK LEVERS 1 2 r 3 Remove the front panel by pressing the release knob Insert the unlock levers into the slots as illustrated Note The jagged Slide down keys side of the key should outward face outward and pull to remove the audio -26- unit
ELECTRICAL CONNECTIONS I-- - I - - P-speaker System - - - (Ga : (Gray/Bl& 0 (Green) i (Green/Bw I (vii (Violet/Black)B \- - - - - - - + 12V Constant Power Supply (Yellow) 3 -I-12VAccessoryDwitched (Red) 4 Ground Wire (Black) 5 Power Antenna (Blue/Red) 6 Amplifier Turn On (BluejWhite) l l l 1 2 3 4 5 6 Left Speaker Right Speaker Do Not Connect Do Not Connect ----- -\ -2’ DO NOT connect any speaker wires to the metal body or chassis of the vehicle Connect each speaker wire directly to each speak
Notes l When using a two-speaker installation, the Green, Green/Black, Violet, violet/Black wires, which are used for a four-speaker installation, are not used The ends of these wires must be covered with electrical tape to prevent them from shorting to the unit or the vehicle chassis l l When using a two-speaker installation, set the FADER control to the center position When fuse replacement is necessary remove the blown fuse by using pliers Then install the new 15 amp fuse NG LINE OUT/CD CHANGER CONN
FM TUNER SECTION Frequency Range Usable Sensitivity 50dB Quieting Sensitivity Frequency Response ( f 3dB) I F Rejection Image Rejection Signal-to-Noise Ratio Selectivity Stereo Separation Capture Ratio Antenna Impedance 87 5MHz - 107 9MHz 15dBf 30dBf 50Hz - 12 5kHz 1OOdB 65dB 60dB 65dB 27dB 2dB 75Q 9M TUNER SECTION Frequency Range Usable Sensitivity (S/N 20dB) I F Rejection Image Rejection SIN Ratio Antenna Impedance 530kHz - 171 OkHz 2opv 80dB 75dB 50dB 75Q rAPE SECTION Wow & Flutter S/N Ratio (Nor
AUDIO SECTION RMS Power Rating (3% THD) RMS Power Rating (10% THD) Maximum Output Power Load Impedance GENERAL Operating Voltage Operating Current Maximum 2OWx4 24Wx4 45Wx4CH (144V) (144V) (15OV) 4R 12V(105-15OV) 13A IMPORTANT INFORMATION Because its products are subject to continuous improvement, SANYO reserves the right to modify product designs and specifications without notice and without incurring any obligation -3o-
